Phenix fibersect.multi User Information

User Information: Connector and Ferrule Adapters

Introduction

The Phenix fibersect.multi​
connector installation. Suitable adapters are available for bare ferrules and for fully assembled connectors.
Single and multi-fiber ferrule and connector adapters are discussed below.

Cut Distance Adjustment

The cut distance from the face of the ferrule is adjusted by rotating the Adjusting Ring. A tool is provided
that engages the two holes in the ring to facilitate rotation. Adapters are shipped with the cut distance
adjusted to ~200 µm. Rotate clockwise to cut closer to the face; rotate counterclockwise to cut further
away. Marks along the adapter ring perimeter represent increments of 25 µm. Any distance (0 to 600
µm+) can be set. Always change the cut distance in small steps and under controlled conditions to
minimize the chance of cutting into the ferrule. The saw will not be noticeably damaged if the ferrule is
accidentally cut, but will wear prematurely if done repeatedly. If the ferrule is cut, adjust the adapter to
increase cut length to avoid continued saw wear.

Adapter Orientation Adjustment

After adjusting for cut distance, adjust the rotational orientation of the adapter, as required and described
below.

Orientation Required

® cuts the epoxy and fiber protruding from the face of the ferrule during
MT 0°
MT 8°
LC-APC
SC-APC
LC-D
FC-APC
MDC
MDC-J
Use the included Orientation Adjust tool to
ensure that the ferrule slot is horizontal with the
engraved arrow pointed down.
Insert a connector and use it to rotate the
adapter until the connector's latch is up.
Rotate the adapter until one connector is directly
above the other with their latches pointed to the
right.
Insert a connector and use it to rotate the
adapter until the key slot is pointing up.
Use the adapter extension to rotate the
adapter so the ferrule holes are horizontal with
the extension below the ferrule holes.
Phenix Fiber Optics, LLC
2011 N. 22nd Ave, Suite 3
Bozeman, MT 59718
sales@phenixfo.com
+1 800 716 8052
www.phenixfo.com
1 of 2