KingShield DAT02A Instructions

Installation / Operating
Instructions For Mains Transformer
Use this transformer in conjunction
with any of the KingShield Hard Wired
Doorchimes when you want to have an
For use with illuminated doorpushes or
when converting a doorpush to an
Please read the instructions fully before
attempting installation. Disconnect electrical
This unit should be installed by a
competent person in accordance with the
current IEE Wiring Regulations.
If in doubt consult a qualified electrician.
This transformer is designed to to be
DIN rail mounted.
1. Connect mains cable to Mains in
terminals and secure cable to prevent
movement. Mains in should be
supplied by a 3A fuse or M.C.B, see
Fig .1 below.
Fig.1
2. Connect the chime bellwire to the 8V
terminals on the transformer and
terminals D and C on a KingShield
wired doorchime. See Fig.2 below.
This gives the required 8V output.
Fig.2
Door Push
3. Switch the power on to transformer
and check operation.
DAT02A
SAFETY
illuminated door push.
illuminated push.
supply before installing.
INSTALLATION
12V
4V 8V
Mains in 230V
Bell wire
DAT02A
230V AC
Doorchime