2. Routine operation On/Off Long press Switch button then the display will work normally, and the controller will power on at the same time. Walk Assist Mode Press and hold Down button for 2 seconds to enter the Walk assist mode. The E-bike will travel at a constant speed of 6km/h.
3. Display Manual Don’t modify system parameters to avoid parameters disorder. If the e-bike is not used for more than 10 minutes, the display will automatically shut down. - 6 -...
4. Installation Instructions ①Open the box, ②Close the folding ③Install the handlebar the bicycle is folded buckle of the frame ④ Close the folding ⑤Install the seat ⑥Install the right riser latch pedal ⑦Done - 7 -...
5. Remove the battery ①Turn the key to unlock ② Release the frame ③Flod up the frame clasp ⑤Remove the battery ④Turn the key until the battery lock is released - 8 -...
Page 9
Appendix 1: Error Code Definition Error code Definition Solution Check whether the brake is restored to the Brake failure initial state Undervoltage Check battery voltage protection Check whether the outgoing cable of phase line is in good condition; Motor failure Check whether the motor phase cable is well connected with the controller Throttle...