Spyder Climb Right Mini Grab Quick Start Manual

A division of Spyder Manufacturing
Read and understand all Instructions
and Warnings before use!
The Climb Right Mini-Clencher
a rope or positioning lanyard by means of a sliding rope grab.

Tools Required:

• 3/32" Allen Wrench
• 3/16" Allen Wrench
• 1/2" Wrench or Socket
1. Remove the nylock nut from the center bolt threads using a
1/2" wrench or socket.
2. Remove the center bolt using a
3/16" allen wrench.
3. Remove the cam and the internal
spring from the body.
4. Remove the internal spring from
the cam by loosening the set screw
with a 3/32" allen wrench
1. Insert spring into the recessed hole in the cam.
2. Using a 3/32" allen wrench, insert the set screw
into the cam and lightly tighten. Over
tightening will cause the spring to distort.
3. Insert the cam into the body making sure
the spring lines up with the small hole.
4. Insert the center bolt and tighten using
a 3/16" allen wrench.
5. Screw on the nylock nut and tighten
with a 1/2" wrench.
6. Arrow must point away from Operator.
6
MINI Grab
is designed to adjust the connection point on
TM
• 3/16 Center Bolt
• Aluminum Cam
• 10-32 set screw

Disassembly Instructions:

Assembly Instructions:

Slide spring into small
• Rope Grab with Internal Spring
• High quality Aircraft aluminum
• Double locking thread security
• Mini Grab fits 3/8" to 1/2" rope
Replacement Parts Available!

Parts Included:

• Aluminium Body
• 1/2" nylock nut
• Internal Coiled Spring
Cam
Spring
3
hole
Center Bolt
1/2" Nylock Nut
Body
Set Screw
1 & 2
Set Screw
Spring
4 5
Insert center bolt
&
and tighten
Screw on nylock nut
and tighten