Freedom Air 2.0 Operation Instruction

Dual remote wireless interchangeable inflator pump

Freedom-Air 2.0 Dual Remote Wireless Interchangeable Inflator Pump

SST

Left

Pressure Scroll Bar

Memory 1

SOFT

Operation Instruction:

1. Plug in the pump, the power indicator will flash slowly for 30 seconds and then stops flashing which

means the system is in standby mode. (Within 30 seconds, press any button to light LCD, then pressing

"FIRM" button for 3 seconds will start to resync. LCD will display "SU" when the pump and remote are

synced again successfully and enter the standby mode. The power indicator will flash when the pump is

working.

2. Press any button to light LCD for operation. If there is no operation after 15 seconds LCD will turn off

automatically to save battery life.

3. LEFT/RIGHT: press "LEFT/RIGHT" button to select left side or right side air chamber for further operation.

LCD will show "L" or "R" accordingly.

4. FIRM: press "FIRM" button for one time, the pump will be activated to inflate and the pressure level

shown on LCD will increase relative to pressure in air chamber, and scroll bar will scroll up to show that

the pressure is increasing. At any time during the period of inflation, pressing any button will stop the

inflation. Or when the pressure reaches the maximum ("50" on LCD), the inflation will stop automatically.

5. SOFT: press "SOFT" button, the pump will be activated to deflate and the pressure level shown on LCD

Operation Instruction

Low Battery Capacity

Memory 2

Right

Pressure Level

FIRM

Memory 2

LEFT/RIGHT

Table of Contents

Need help?

Do you have a question about the Air 2.0 and is the answer not in the manual?

Page 1 Freedom-Air 2.0 Dual Remote Wireless Interchangeable Inflator Pump Operation Instruction Low Battery Capacity Memory 2 Memory 1 Right Left Pressure Level Pressure Scroll Bar FIRM Memory 1 Memory 2 SOFT LEFT/RIGHT Operation Instruction: 1. Plug in the pump, the power indicator will flash slowly for 30 seconds and then stops flashing which means the system is in standby mode.
Page 2 D) Air Chamber Dimension Detection: to display the pressure level in air chamber accurately, Freedom-Air 2.0 Wireless Inflator Pump has a function to measure and record air chamber dimension automatically when it works in the first few times.
Page 3 FCC Caution： This device complies with part 15 of the FCC Rules. Operation is subj e ct to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.