Cleaning And Maintenance; Troubleshooting - easymaxx ZX-150C Operating Instructions Manual

Gas Cooker
CLEANING AND
MAINTENANCE
Please Note!
■ Do not make any modifications to
the device! Any change to the device
may be dangerous.
■ Allow all parts to cool down before
cleaning them and remove the gas car-
tridge from the device.
■ Do not do any cleaning on the gas
connection and other components that
carry gas! They are sensitive and could
be damaged.
■ Do not immerse the device in water and
make sure that no liquid gets inside the
components which carry gas.
■ Never pour cold water onto hot parts.
This may cause burns and damage the
material.
■ Never use methylated spirit or other flam-
mable or corrosive cleaning products.
■ Do not use abrasive cleaning agents.
■ All parts must be dry before they are
used or stored away.
• Keep the device clean. Remove any dirt
or contamination (sand, insects, grass,
fat deposits, etc.).
• Wipe down the outside of the device
with a damp cloth. Use a little house-
hold cleaning agent or detergent on
stubborn dirt. Then wipe it dry.
• Otherwise the device does not require
any maintenance. Only a specialist may
replace the gas nozzle.
• Check whether the sealing ring (7) is
undamaged at regular intervals. If it is
damaged, it must be replaced.
If the seal is defective:
Remove the seal (standard O-ring,
13.5 x 1.9 mm) and carefully insert a new
seal.
Cleaning the Burner (if Necessary)
The burner (1) may be clogged up and need
to be cleaned if
• a smell of gas along with a very yellow
and weak burner flame is detected.
• the desired temperature is not reached.
• the burner heats unevenly or the flame
flickers.
Proceed as follows to perform cleaning:
• Clean the burner with a clean brush to
remove any dirt or food residues. Make
sure you do not bend or damage the
ignition electrode.

TROUBLESHOOTING

If the device does not work properly, check
whether you are able to rectify the problem
yourself. If the problem cannot be solved
with the steps listed, contact the customer
service department.
Do not attempt to repair the
device yourself!
The burner does not ignite.
The gas cartridge is empty.
► Replace the gas cartridge.
The burner is clogged up.
► Clean the burner in the manner de-
scribed in the "Cleaning and Mainte-
nance" chapter.
There is a smell of gas (possibly ac-
companied by a very yellow and weak
flame).
The burner is clogged up.
► Clean the burner in the manner de-
scribed in the "Cleaning and Mainte-
nance" chapter.
The desired temperature is not reached. /
The flame is small or flickers a lot.
The gas cartridge is (almost) empty.
► Replace the gas cartridge.
EN
15