Custom Dynamics PROBEAM PB-KIT-BCM-1156-T Manual

We thank you for purchasing the Custom Dynamics® ProBEAM® LED Turn Signals! Our LEDs offer maintenance free
service and higher visibility. Our ProBEAM® product line utilizes the latest technology and automotive grade compo-
nents to ensure the highest level of reliable service. Custom Dynamics® offers one of the best warranty programs
and customer support in the industry. If you have any questions during the installation of this product please call us
at 1(800) 382-1388.
Part Number: PB-KIT-BCM-1156-T
Package Contents:
- Choice of Front 1157 ProBEAM® Amber/White Dynamic
Ringz ™ Lenses with Smoke Lenses or ProBEAM® Amber
LED Turn Signals with Amber Lenses
- Choice of Rear 1156 ProBEAM® Red LED Turn Signals with
Red Lenses Inserts or ProBEAM® Amber LED Turn Signals
with Amber Lenses
US Patent: 830597, 830595, D851,817, D851,327
Chinese Patent: ZL201830045649.4, ZL201830409095.1,
ZL201830409102.8, ZL201830409095.1
Fitment:
2011-2017 Harley-Davidson® Heritage Classic
(FLSTC) and 2014-2021 Road King® (FLHR) with OEM Flat
(Pancake) Style (2-screw) lens and rear 1156 single con-
tact bulb bases (models with center taillight). Does not fit
CVO™ models or International (HDI) Harley-Davison® Mo-
torcycles.
ATTENTION
Please read all Information below before Installation
Note:
•
Use care in removing the OEM lens and bulbs from the
housing, so as not to scratch or mar the chrome housing.
Custom Dynamics® is not liable for damage to chrome
housing during installation.
•
Dielectric grease does not need to be used with this LED
product, it can actually prevent them from working. Re-
move any excess grease from your turn signal sockets be-
fore inserting.
***IMPORTANT***
CAN Bus Models: 2011-Present Softail, 2012-Present Dyna, 2014
-Present Touring, 2014-Present Sportster
This LED product is BCM compliant. However, you must run the
4 way hazard flashers for 3 minutes with the ignition in the OFF
position to allow the BCM to sync the new LED turn signals load
after they are installed.
Questions? Call us at: 1 (800) 382-1388 M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST
CD #: PB-KIT-BCM-1156-T
Installation:
1. Remove the existing lens from turn signal housing by
removing the two screws.
2. Remove existing bulb from turn signal housing.
3. Remove any corrosion or dielectric grease from the
socket to insure the socket contacts are clean.
4. Confirm the proper orientation of the socket base and
insert the base into the socket. If it seems hard to
twist the base in the socket or hard to remove, it is
probably orientated the wrong way.
Twist the LED turn signal a few rotations to coil wire
5.
from the turn signal to the socket base ( Figure 1).
1
02-2021