Connecting The Water Line To The Water; Supply; Installing The Internal Water Filter; Before Using The Water Dispenser - Beko BFFD3626ZSS User Manual

Installation
4.10 Connecting the water line
to the water supply
Connect the water line to a water supply valve. If a
valve is not present or you are not sure, consult a
qualified plumber.
4.11 Installing the Internal
Water Filter
Installing the internal water filter consists of two
steps:
1. Press and hold the Freezer Temp Set key
seconds, or until the no ice icon appears in the display.
2. Slide the filter cover forward to open the filter
compartment.
3. Tilt the bypass plug down and pull straight out to
remove it.
4. Insert the filter into the housing and push it up to a
horizontal position.
5. Close the filter cover and push it back into place.
6. Press and hold the Freezer Temp Set key
again for 3 seconds.
The Filter End of Life warning
approximate 130 days, requiring you to replace
the filter with the same steps as listed above. After
key for 3 seconds, or until the Filter End of
Life Warning goes out in the display.

4.12 Before using the water dispenser

The water system connections should be made
by an Authorized Service Agent, with the necessary
tools.
only with water. Do not attempt to connect to
beverages such as soft drinks or juices.
bled out of the system before the intial use.
To remove the air in the line, place a container
beneath the water dispenser nozzle and depress
the dispenser paddle for 1-2 minutes until only
water comes out.
consumed.It will take approximately 12 hours
before the water being dispensed cools down to
refrigerated temperatures.
paddle before removing your container, as this
will reduce the potential for dripping into the
for 3
dispenser tray.
16 319 EN
will appear in
Refrigerator / User Manual