Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for MOTION BLINDS RAAMDECORATIE CM-08
Summary of Contents for MOTION BLINDS RAAMDECORATIE CM-08
- Page 1 M O T I O N B L I N D S M A N U A L Handleiding Elektrische plisségordijnen MOTOR CM-08...
- Page 2 Pair a remote control Any MOTION Blinds remote can be connected to your blind. Select a channel on the remote and press the program button on the motor to activate program mode. The blind will start stepping up and down.
- Page 3 Set bottom position Press and hold the down button until the blind reaches the desired bottom position. WARNING: risk of damage. Slowly approach the bottom position. Down Save bottom position Simultaneously hold the centre and the up button until the blind stops stepping and starts stepping again.
- Page 4 Set top position Press and hold the up button until the blind reaches the desired bottom position. WARNING: risk of damage. Slowly approach the top position. Save top position Simultaneously hold the centre and the down button until the blind stops stepping and starts stepping again.
- Page 5 Set favorite position (optional) Move the blind to a desired favourite position. Hold the centre button to save this Favourite position. The blind shortly stops stepping indicating the favourite position has been saved. Centre Deactivate program mode Shortly press the program button to deactivate program mode. The blind stops stepping and can be operated.
- Page 6 Deactivate direct control for remote control When pressing the up or down button on the remote control, the blind directly moves to its end positions (direct control). To operate the blind with smaller steps using the up and down button, direct control can be deactivated. Now, the blind only directly moves to its end positions when the up or down button is held longer than two seconds.
- Page 7 Top-down/bottom-up (bottom rail) Top-down/bottom-up blinds are powered by two motors: one for the bottom rail and one for the middle rail. The motors need to be programmed individually: rst the bottom rail motor and then the middle rail motor. Pair the bottom rail motor to an empty channel on the remote. (see step 1) Centre Centre Down...
- Page 8 Top-down/bottom-up (middle rail) Pair the middle rail motor to an empty channel on the remote. (see step 1) Centre Centre Down Check the direction of rotation of the middle rail (see step 2) and move the bottom rail to the desired top position.
- Page 9 Activate / deactivate the motor (Transport mode) To prevent the blind from getting damaged, the motor has a transport mode that makes sure the blind will not be activated before installation. Hold the program button and pull twice to activate or deactivate the motor. Problem Cause Solution...
Need help?
Do you have a question about the RAAMDECORATIE CM-08 and is the answer not in the manual?
Questions and answers