Comelit RF10VEDO Technical Manual

Technical manual for two-way radio expansion devices on
bus Art. RF10VEDO / RF32VEDO
WARNING
• Install the equipment
instructions given by the manufacturer and in compliance
with the standards in force.
• All the equipment must only be used for the purpose it
was designed for. Comelit Group S.p.A. declines any
responsibility for improper use of the apparatus, for any
alterations made by others for any reason or for the use
of non-original accessories or materials.
• Installation, mounting and assistance procedures for
electrical devices must only be performed by specialised
electricians.
• For standard-compliant installation, a suitable (two-pole)
device must be provided for isolating and protecting the
mains power supply in the building's electrical system
(see Figure), in compliance with current standards (law
46/90): for example, a two-pole overload circuit breaker
with rated current 6A.
Two-pole isolating
device example:
Control
panel
Wiring diagram: two-pole mains switch (for
example overload circuit breaker with rated
current 6A) able to isolate the power supply of
the device.
Maintenance
• Cut off the power supply before carrying out any
maintenance work.
• It is recommended to check the correct operation of the
safety system periodically (at least once a month).
• Remove any dust accumulated in the control panel
housing with a damp cloth, without using any solvent,
and check that there are no foreign bodies.
The modules operate in two-way mode (reception
and transmission). This makes it possible to pair
radio controls, radio alarm sensors (contacts and/or
volumetric detectors) and supervised wireless sirens
with the control panel.
by carefully following
EARTH
NEUTRAL
PHASE
230 V
50 Hz
EN
TECHNICAL
MANUAL
• Check the condition of the connectors and the
the conductors.
• Perform the maintenance and operation tests of all
components (smoke sensors, movement sensors, ...) as
indicated in the relevant technical manuals.
• Replace the protections on the terminals.
Certifications
• All the products comply with the requirements of
Directive 2006/95/EC (which replaces Directive 73/23/
EEC and subsequent amendments), as certified by the
CE mark they carry.
• Art. VEDORF complies with standards EN50131-1,
EN50131-3, EN50131-5-3
• All the system components must have safety grade 2
or higher to obtain grade 2 alarm system certification
according to standard EN50131.
Product labels
• All items have a product ID label. An example is provided
below:
article
code
article VEDORF
code
interpretation serial number:
date of manufacture
week of manufacture (WW)
and year of manufacture (YY)
(in the sample label
1515= week 15 of the year 15)
Art. RF10VEDO / RF32VEDO complies
with standards EN50131-1, EN50131-3,
EN50131-5-3
Passion.Technology.Design.
VEDORF
000P1515XXXXXXXX
000P1515XXXXXXXX
000PWWYYXXXXXXXX
protocol number
manufactur-
er's name
EAN article
identification
code
serial number
serial number