Martellato 50T002 User Manual

50T002
ENG
A. INTRODUCTION
This infrared thermometer is used for measuring the
temperature of the object's surface, which is applicable
for various hot, hazardous or hard-toreach objects
without contact safely and quickly.
This unit consist of Optics, Temperature Sensor Signal
amplifier, Processing circuit and LCD Display. The
Optics collected the infrared energy emitted by object
and focus onto the Sensor. Then the sensor translates
the energy into an electricity signal. This signal will be
turned out to be digital shown on the LCD after the
signal amplifier and processing circuit.
B. WARNING & CAUTIONS
1. Warning:
To avoid the potential situation may cause harm or damage to people, please pay attention to the following
items:
1) Do not point laser directly at eye or indirectly off reflective surfaces.
2) The unit cannot measure through transparent surfaces such as glass or plastic. It will measure the surface
temperature of these materials instead.
3) Steam, dust, smoke, or other particles can prevent accurate measurement by obstructing by the units optics.
2. Cautions:
Infrared thermometer should be protected for the following:
1 ) EMF (electro-magnetic fields) from arc welders, induction heaters.
2) Thermal shock (cause by large or abrupt ambient temperature changes allow 30 minutes for unit to stabilize
before use).
3) Do not leave the unit on or near objects of high temperature.
C. DISTANCE TO SPOT SIZE
1. When take measurement, pay attention to the Distance
to Spot Size. As the Distance (D) from the target surface
increases, the spot size (S) of the area measured by the unit
becomes larger.
The Distance to Spot size of the unit is 12:1.
This unit is equipped with a laser, which is used for aiming.
2. Field of view:
Make sure the target is larger than the unit's spot size.
The smaller the target the closer measure distance. When
accuracy is critical, make sure the target is at least twice as
large as the spot size.
INFRARED THERMOMETER
38mm@ 75mm@
D:S=12:1
300mm 900mm
1.5"@ 3.0"@
12"
36"
132mm@
1500mm
5.3"@
60"