Table of Contents
Advertisement
Section 2
Getting Started
Loading the Battery
Before using the camcorder, you must load the Lithium-ion
rechargeable battery come within the package.
1. Insert the battery according to the correct polarity marks ( + or -).
2. Close the battery cover firmly.
Charge your battery
You must use the supplied AC charger or the USB cable. The camcorder
must be turned OFF. The blinking light confirms the camcorder is currently
charging, and the light becomes constant after the charging is completed. In
AC charging Mode, the light will turn itself off automatically after 3~5 minutes
. The full charge time is about 4 to 5 hours. (Actual charging time may vary. It
depends on the battery conditions.)
Inserting and Removing an SD Card (Optional)
The camcorder comes with an internal memory that allows you to store photos and videos. You can
expand the memory capacity by using an optional SD memory card.
1. Insert the memory card into the slot. Please refer to the figure on
the right side.
2. To remove the installed SD card, press the card inward to release it.
3. When the card pops out, gently remove it from its slot.
4. Recommended memory capacity: 1GB or above.
Note
• When a memory card is fitted, videos/photos are saved to the card rather than the built-in
memory.
• Protecting Data on an SD Card: SD Card is read-only when it is locked. No photos or videos can
be recorded when the SD card is locked. Make sure
the lock is on the writeable position before recording
any media.
Writeable
position
7
Write-Protected
Position
Advertisement
Table of Contents
