Advertisement
steps
1
The lower side (L1) & (R1) panels feature:
→ channels for the grille & tray — make sure
channels face interior of cage;
→ tabs at the bottom which correspond to
sleeves on the legs of the front & back panels
(see detail).
Slide the tabs on the left side lower (L1)
panel down into the sleeves on the legs of the
front (F) and back (B) panels.
Install one long hex screw through the front
and back panels into the top corners of (L1)
and tighten with the allen wrench to secure
panel in place.
Repeat installation steps for right side lower
(R1) panel.
2
With the lower side panels installed, carefully
lay the cage on its side as illustrated.
Install rolling casters in each leg post.
After casters have been installed, carefully
upright the cage and continue assembly.
L1
B
F
R1
L1
3
The upper side (L2) & (R2) panels:
→ slide down into channels along the inside rails
of the front and back panels (see detail [a] );
→ have a center vertical wire extending beyond
the top and bottom horizontal wires.
Slide left side upper (L2) panel (with cup doors)
down into place, making sure panel is centered
within all channels. Align lower extended vertical
wire with hole on top edge of (L1) rail (see detail
[b]). When panel is installed correctly, cup door
locks are on the outside of the cage.
Repeat installation steps for right side upper
(R2) panel.
4
The center top (C) panel:
→ has two vertical wires extending beyond the
top and bottom horizontal wires.
→ has one small hole centered on the underside
of each side rail;
Align the two extended vertical wires
on the center top (C) panel with the two
corresponding holes on the inside rails
of the (F) & (B) panels (see detail [c]).
Align the underside holes on the center top
(C) panel side rails with the extended vertical
wires on (L2) & (R2) panels (see detail [d]).
When all extended wires and corresponding holes
are aligned, secure center top (C) panel with a long
hex screw in each corner.
R2
L2
a)
b)
C
c)
d)
Advertisement
