fine fixtures TDP1 Installation Manual

Tub panel pivot frameless

Advertisement

Quick Links

206 Wembly Road
New Windsor, NY 12553
Phone: 718.602.6060
Fax: 718.963.2082
info@finefixtures.com
www.finefixtures.com
INSTALLATION
MANUAL
TUB
PANEL
PIVOT FRAMELESS
MODELS:
TDP1-28
TDP1-34
MODEL# TDP1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TDP1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for fine fixtures TDP1

  • Page 1 206 Wembly Road New Windsor, NY 12553 Phone: 718.602.6060 Fax: 718.963.2082 info@finefixtures.com www.finefixtures.com INSTALLATION MANUAL PANEL PIVOT FRAMELESS MODELS: TDP1-28 TDP1-34 MODEL# TDP1...
  • Page 2 READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT INSTRUCTIONS THAT, IF IGNORED, COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION. ATTENTION! PEOPLE ARE REQUIRED TO LIFT AND DURING ENTIRE INSTALLATION OF THIS PRODUCT INSTALLATION OF THIS PRODUCT BY AN INEXPERIENCED INSTALLER MAY RESULT...
  • Page 3 PARTS COMPONENTS AND HARDWARE During unpacking the product and prior to installation inspect your new product for any damages or missing parts. Do not attempt to install or operate the product if the product is damaged. Part Plastic Ø8 Anchor Pieces Part Door...
  • Page 4 ATTACHING DOOR SEAL STRIPS Attach a plastic seal strip (C) to the vertical side of the door (D) first. Attach the seal strip (G) to the horizontal lower side of the door (D).
  • Page 5 ATTACHING THE DOOR HINGES Attach the door hinges (B) to the door (D) using screws included with the hinges.
  • Page 6 ATTACHING THE DOOR TO THE WALL Use a pencil to mark the two places on the wall where the screws will be inserted. Leave a 5/8” gap from the bottom, to insert the seal strip. Use a size 8 drill bit to drill holes at the marked points.
  • Page 7 ATTACHING THE DOOR TO THE WALL Place the door (D) against the wall, lining up the joints (B) with the drilled holes. Attach the door joints (B) to the wall, using screws (F). Tighten with the Allen key. ATTACHING THE DOOR HANDLE Attach the handle (E) to the center of the door using screws included...
  • Page 8 INSTALLATION COMPLETED When complete, the door should appear as the image below. AFTER INSTALLATION WAIT 24 HRS BEFORE USE F I N E F I X T U R E S 206 WEMBLY ROAD - NEW WINDSOR, NY 12553 P: 718.602.6060 F: 718.963.2082 - E: INFO@FINEFIXTURES.COM TOLL FREE: 1.877.8FIXTURES FINEFIXTURES.COM RETAIN THIS INSTALLATION MANUAL FOR FUTURE REFERENCE.

This manual is also suitable for:

Tdp1-28Tdp1-34Tdp1-28pc

Table of Contents