Subscribe to Our Youtube Channel
Related Manuals for AMP Lighting G2 AAC-HUB2-LI-SS
Summary of Contents for AMP Lighting G2 AAC-HUB2-LI-SS
- Page 1 INSTALLATION & MAINTENANCE GUIDE Line Voltage Landscape Lighting ® ® G2 Line-Voltage Junction Hub (120V) AAC-HUB2-LI-SS Help Hotline: 1-813-978-3900 • Mon-Fri 9am-6pm (EST) w w w. a m p l i g h t i n g . c o m...
- Page 2 INSTALLATION & MAINTENANCE GUIDE G2 Line-Voltage Junction Hub (120V) ® AAC-HUB2-LI-SS Important Safety Instructions: Read Before Installation This connection hub is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.
- Page 3 Dig A Hole for Line Voltage Hub Line Voltage Hub Ground 3” 3” 3” Soil Dig a hole in the ground at the desired location. Make sure there is approximately 3 inches surrounding the line voltage hub for pea gravel or sand on all sides.
- Page 4 INSTALLATION & MAINTENANCE GUIDE G2 Line-Voltage Junction Hub (120V) ® AAC-HUB2-LI-SS Remove Lock Nut from Coupler Remove the lock from the Coupler coupler. (Sold Separately) Waterproof Washer Lock Nut Install Coupler to Cover Coupler Place the coupler with the (Sold Separately) waterproof washer through the top of the hub.
- Page 5 INSTALLATION & MAINTENANCE GUIDE G2 Line-Voltage Junction Hub (120V) ® AAC-HUB2-LI-SS Install Conduit Wrench Lock Nut Hub Body Waterproof Seal Wrench Waterproof Washer Hub Body Allen Wrench Lock Nut Lock Nut Waterproof Washer Conduit Conduit 1. Loosen the lock nuts to remove the waterproof wire seals from the hub body.
- Page 6 INSTALLATION & MAINTENANCE GUIDE G2 Line-Voltage Junction Hub (120V) ® AAC-HUB2-LI-SS Wire Connections Supply Cable “HOT” Block from Fixture Supply Cable from “GROUND” Block other Fixture or “NEUTRAL” Block next hub Hub Body Conduit Main Supply Cable Open the clamp on the connector that you are going to insert the wire in, insert one side of the supply wire into the connector and close the clamp.
- Page 7 INSTALLATION & MAINTENANCE GUIDE G2 Line-Voltage Junction Hub (120V) ® AAC-HUB2-LI-SS Attach Cover Allen Wrench Place the cover back onto the hub ensuring the gasket Screw is in place. Secure with the previously removed screws. Cover Hand tighten until snug with the provided Allen wrench.
- Page 8 Help Hotline: 1-813-978-3900 • Mon-Fri 9am-6pm (EST) Specifications and product details subject to change without notice. © Copyright 2023, AMP Lighting, Lutz FL USA 33549 • All rights reserved. ® customersupport@amplighting.com • 813.978.3900 w w w. a m p l i g h t i n g . c o m IS-AAC-HUB2-LI-SS-ver1.pdf...
Need help?
Do you have a question about the G2 AAC-HUB2-LI-SS and is the answer not in the manual?
Questions and answers