Summary of Contents for GARO SR3
- Page 1 INSTALLATION MANUAL GARO SR3 Stove Guard Power Control Unit: PCU6.1-F 22018_01-A For PCU software versions x.x.14 and onwards...
- Page 2 ❷ Adjustment button lock or integrated switch-off system ❸ OK-button ❶ Adjustment button GARO SR3 is compatible with cookers no Low battery light ❺ wider than 90 cm, see chapter 2. Installa- tion step 2/2. ѥ WARNING Please contact your vendor if you notice anything unusual about the appliance.
- Page 3 INSTALLATION - STEP 1/2 Mount the Power Control Unit Ⓒ PCU6.1-F Fixed 1-phase connection. 78 mm 60 mm Optional AUX and water 225,5 mm sensor connections. See chapter 5. 42 mm 230V MAX. 25/32A* MICRO DISCONNECTION 239 mm * Check specifications on the cover of the Power Control Unit.
- Page 4 3. Test that none of the cooker plates and ѧ HINT ⚐ ATTENTION oven (if connected to the stove guard) are operable: if ok, switch off cooker SR3 will automatically recognize the Ensure the correct sensor direction: and oven. cooker type during cooking to minimize both sensors ❻...
- Page 5 3. INSTALLATION TROUBLESHOOTING 4. MANUAL ADJUSTMENT MODE To enable the fast installation, the default settings of GARO SR3 are suitable for the most Problem Remedy typical installations. In case you need to install the sensor unit outside the default instal- Problems with checking •...
- Page 6 4.3 Mode 3: Manual calibration of the cooker type Table 2. The new alarm limit is indicated as shown in the table below: Color of the indicator light ❹ Number of beeps Alarm Limit When the indicator light ❹ is blinking yellow-green, you may manually calibrate the cooker •••...
- Page 7 When the indicator light ❹ is blinking white (normal AUX-mode) or a blinking red (inversed 5.1 AUX-connection (optional) AUX-mode, see chapter 5.1.), you may: GARO PCU6.3 and PCU6.1 power control units Ⓒ are equipped with two auxiliary output • Test the AUX-connection: signals AUX1 and AUX2 compatible with most automation and security systems.
- Page 8 ON most of the time. For example, this may be harder for battery operated external • Simple ON/OFF information for a fault condition. This can be read directly when both clients. However, it will not affect the GARO system's own battery life. AUX1 and AUX2 are connected in series to the same line. •...
- Page 9 5.2 Water leakage sensor (optional) Stove Guard can be equipped with max. four GARO water leakage sensors. The sensors are placed in the typical leakage areas, e.g. under the dishwasher or sink. Attach the sensors Ⓕ in place. Attach the plug Ⓖ of the leakage sen- sor to the power control unit Ⓗ.
- Page 11 USER MANUAL GARO SR3 Stove Guard 22019_01-A...
-
Page 12: Table Of Contents
1. INTRODUCTION User Manual 1.2 Battery safety information Follow these instructions carefully and pay particular attention to the instructions Congratulations for buying the GARO SR3 Contents marked in the following way: ѥ WARNING Stove Guard. This guide describes the use and maintenance of the product. -
Page 13: Stove Guard Description
2.3 Appliance Description adhesive tape SAFERA Stove Guard is designed to im- GARO SR3 can be mounted on the wall or prove the safety of electrical cookers on the bottom of the cooker hood above meant for household use (see compatibility the cooker. -
Page 14: Using The Stove Guard
3. USING THE STOVE GUARD 3.2 Automatic Child Proof Lock 3.4 Cooker danger 3.5 Water Leakage Detector SAFERA Stove Guard observes the tem- perature changes and the use of the cook- (optional) By default, automatic child proof lock is dis- Warning for dangerously hot cooker or for er. -
Page 15: Maintenance
4. MAINTENANCE 4.3 Battery replacement To ensure continued safe and reliable op- 4.1.2 Cleaning eration, please follow the instructions in Wipe the Sensor unit Ⓐ with a cloth mois- 1. Remove the sensor unit Ⓐ from the this chapter. ⚐ ATTENTION tened with water or a mild detergent, such mounting bracket Ⓑ... -
Page 16: Personizing The Stove Guard
5. PERSONALIZING THE STOVE GUARD 6. TROUBLESHOOTING You may change the color of the stove Press the OK button ❸ to find out the problem type by the indicator light ❹: ѧ HINT guard with the provided color labels. The You may print your own color label and stove guard is delivered with 10 different Indicator light ❹ blinks in blue:... -
Page 17: Specifications
7. SPECIFICATIONS 8. CE CONFORMITY 9. WARNINGS AND LIMITATIONS OF LIABILITY GARO ensures that SR3 fullfils all compli- Sensor Unit ѥ WARNINGS THE EXTENT THE MANDATORY LAW ant EU directives and standards: Battery type AA/LR6 Alkaline. ALLOWS THIS KIND OF DISCLAIMER. -
Page 18: Warranty
10. WARRANTY Warranty terms available from Garo Elec- tric Ireland Ltd. 11. LICENSE TERMS AND CONDITIONS 11.1 Software License The software included and/or embedded in the Products may be used only as in- tegrated in the Products when using the Products in their designed use.
Need help?
Do you have a question about the SR3 and is the answer not in the manual?
Questions and answers