AEG TR9MUNCHEN User Manual page 29

12.2 Troubleshooting
Problem
The tumble dryer is not connected
to the mains supply.
The door is open.
The tumble dry‐
er does not op‐ The Aan/Uit button was not push‐
erate. ed.
The Start/Pauze button was not
touched.
The appliance is in standby mode.
Incorrect program selection.
The filter is clogged.
Droogtegraad option was set to
The load was too large.
Unsatisfactory
drying result.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi‐
The loading
tion.
door does not
Laundry is trapped between the
close
door and the seal.
It is not possible After a cycle starts it is not possi‐
to change the ble to change the program or op‐
program or op‐ tion.
tion.
It is not possible The option you tried to select is not
to select an op‐ available for the selected program.
tion. An acoustic
signal is emit‐
ted.
Possible cause
3)
strijkdroog .
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
Close the door.
Push the Aan/Uit button.
Touch the Start/Pauze button.
Push the Aan/Uit button.
Select a suitable program.
2)
Clean the filter.
Change Droogtegraad option to a
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct position.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the program or option as
required.
Turn the tumble dryer off and on.
Change the program or option as
required.
ENGLISH 29
1)
4)
2)