REMOTE CONTROL
BUTTON
BUTTON
FUNCTION
FUNCTION
POWER
MY FLAME
MAIN FLAME/
FLAME PALETTE
FLAME SPEED
The POWER button will turn the fireplace on, and enter standby mode.
This will turn on/off all the functions at once but will hold the settings in memory.
Press the MY FLAME button followed by '+' and '-' or '
settings.
Flames 1-6 are default settings, 7-9 can be saved as custom settings.
Press the MAIN FLAME button to enter the main flame effect adjustment screen, press '
button to cycle through Red - Ember - Yellow - Green – Cyan - Blue – Purple – White – 8 Colour
Cycling - Off.
Press '+' and '-' button to adjust the brightness from 10 -100%, total six settings including Off.
Press again to enter the FLAME PALETTE adjustment screen. Press '
through Red - Ember - Yellow - Green – Cyan - Blue – Purple – White – 8 Colour Cycling - Off.
Press '+' and '-' button to adjust the brightness from 10 -100%, total six settings including Off.
Press the button to enter the FLAME SPEED settings.
Press '+' and '-' button to adjust the speed by five settings.
ACTION
ACTION
f
' and '
g
' , the unit will cycle through 9 flame
' and '
f
The remote control should be left on
a flat surface in the room where the
appliance is installed and away from
any direct flow of hot air.
f
' and '
g
'
' button to cycle
g