Storing Channels Automatically; Troubleshooting - Samsung 8 Series Quick Start Manual

Storing Channels Automatically

Scans for all channels with active broadcast stations (and availability depends on your
country) and stores them in the TV's memory.
You can memorize the Antenna source.
Air : Air antenna signal.
•
• Cable : Cable antenna signal.
• Air+Cable : Air and Cable antenna signals
If the antenna is connected to ANT 2 IN (CABLE), select
N
connected to ANT 1 IN (AIR), select Air.
If both ANT 1 IN and ANT 2 IN are connected, select the
N
After all the available channels are stored, it starts to remove scrambled channels.
N
The Auto program menu then reappears.
If you want to stop Auto Programming, press the
N
The Stop Auto Program? message will be displayed. Select Yes by pressing the
◄ or ► button, then press the ENTER

Troubleshooting

Before contacting the Samsung after-sales service, perform the following simple checks.
N
If you cannot solve the problem using the instructions below, note the model and serial number of the television and contact
your local dealer.
No sound or picture
Normal picture but no sound
No picture or black and white
picture
Sound and picture
interference
Blurred or snowy picture,
distorted sound
Remote control malfunctions
Screen is black and power
indicator light blinks steadily
The damaged picture appears
in the corner of the screen.
The "Resets all settings to
the default values" message
appears.
02169A_CMS.indd 3
Cable and if it is
Air+Cable.
ENTER button.
E
button.
E
• Check that the mains lead has been connected to a wall socket.
• Check that you have pressed the button on your set.
• Check the picture contrast and brightness settings.
• Check the volume.
• Check if Select Speaker is set to External Speaker.
• Check the volume.
• Check whether the M MUTE button has been pressed on the remote control.
• Adjust the colour settings.
• Check that the broadcast system selected is correct.
• Try to identify the electrical appliance that is affecting the television, then move it further away.
• Plug the television into a different main socket.
• Check the direction, location and connections of your aerial.
This interference often occurs due to the use of an indoor aerial.
• Replace the remote control batteries.
• Clean the upper edge of the remote control (transmission window).
• Check that the + and – ends of the batteries are inserted correctly.
• Check that the batteries are drained.
• On your computer check; Power, Signal Cable.
• Move the computer's mouse or press any key on the keyboard.
• On your equipment check (STB, DVD, etc) ; Power, Signal Cable.
• The TV is using its power management system.
• Press the Source button on the panel or remote control.
• Turn the TV off and on.
• If Screen Fit is selected in some external devices, the damaged picture may appear in the
corner of the screen. This symptom is caused by external devices, not TV.
• This appears when you press and hold the
reset to the factory defaults.
3
Antenna
Auto Program
Full Guide
Mini Guide
Default Guide
Channel List
Fine Tune
LNA
EXIT button for a while. The product settings are
: Air
►
: Full Guide
: Off
2009-09-08 1:46:40