Table of Contents
Advertisement
Quick Links
Technical Manual
BARREIRA
DE CORRENTE BC1
ATTENTION:
Do not use the equipment
Made by: Motoppar Indústria e Comércio de Automatizadores Ltda
without first reading the
Av. Dr. Labieno da Costa Machado, 3526 - Distrito Industrial - Garça - SP - CEP 17406-200 - Brasil
instruction manual.
CNPJ: 52.605.821/0001-55
P30568 - 04/2022
Rev. 0
www.ppa.com.br | +55 14 3407 1000
Advertisement
Table of Contents
Related Manuals for PPA BC1
Summary of Contents for PPA BC1
- Page 1 Made by: Motoppar Indústria e Comércio de Automatizadores Ltda without first reading the Av. Dr. Labieno da Costa Machado, 3526 - Distrito Industrial - Garça - SP - CEP 17406-200 - Brasil instruction manual. CNPJ: 52.605.821/0001-55 P30568 - 04/2022 Rev. 0 www.ppa.com.br | +55 14 3407 1000...
-
Page 2: Table Of Contents
RECOMMENDATIONS ..........14 BC1 BASE FLEX (PRODUCT SOLD SEPARATELY ) ..... 14 OPERATION . -
Page 3: Internal Cabinet Components
INTERNAL CABINET COMPONENTS GENERAL FEATURES • BC1 cabinet that allows the installation of the chain for use in private or BASE AND INVERTER COVER public car parks and in residential and commercial areas; • Electronic board with frequency inverter GEAR MOTOR •... -
Page 4: Equipment Dimensions
Piping 168mm 190mm DEFAULT INSTALLATION Concrete base BC1 with geared motor and BC1 with geared motor Triflex connect board (slave) Concrete base Note: Measurements in millimeters. It is very important that the base is level; this will allow the product to perform better. -
Page 5: Installation Precautions
4. Insert the parabolts into the holes in the base as shown below. 1. 1. When fixing the BC1, note that the front of the cabinet must face the Note: The parabolts must not be inserted completely, they must be more or side of the road or the place where vehicles pass. - Page 6 8. For a better fixing of the cabinet, it is recommended to release the side plates of the cabinet from the fixing plate of the concrete base. CABINET BASE 11. Power/energize BC1 according to product voltage purchased (127V CABINET FIXING or 220V).
- Page 7 12. Check/set the chain alignment (opening and closing). Use mechanical 14. BC1 will be in good working condition at closing, when the current is stops for this situation, moving them as needed. in the conditions shown below in the image.
-
Page 8: Recommendations
RECOMMENDATIONS OPERATION For the safety of vehicles and for the protection of BC1 against possible BC1 operation is done by a board with frequency inverter, activated via damage caused by collision with the chain, it is recommended to place remote control or any other device that provides a NO (normally open) a breaking device or splice the end of the chains with a hellerman clamp contact.
Need help?
Do you have a question about the BC1 and is the answer not in the manual?
Questions and answers