Summary of Contents for Kwunphi T1
- Page 1 High Pressure Cleaner T1 Manual Implementation Standards: T/ZZB 0231-2017 Please Read The Instructions Carefully Before Using The Machine ShenZhen Kwunphi Robot Co.,LTD...
- Page 2 Content 1.Safety Information 2.Assembly/Operating Instruction 3.Maintenance and Warranty 4.Motor Maintenance and Repair 5.Motor Storage and Transportation 6.Troubleshooting...
- Page 3 1. Safety Information: It is necessary to read the manual carefully and understand it completely before using the machine. The symbols listed below are used to indicate this information: DANGER: Potential hazard that will result in severe injury or loss of life WARNING: Hazard that could result in severe injury or loss of life CAUTION:...
- Page 4 ！WARNING 7.Before using machine, please read though this operation manual at first in case of any potential hazard and unnecessary loss which may cause by misuse. Be sure you know how to stop machine in emergency quickly. Be thoroughly familiar with the controls. Read and understand the manual before any operation or maintenance.
- Page 5 ！CAUTION 24.Store the pressure washer indoors to prevent the water in the unit from expanding under freezing conditions. 25.NEVER leave the pressure washer unattended while it is powered "ON" . 26.ALWAYS turn the water supply on before turning the pressure washer on. Running the pump dry will cause damage to the machine.
- Page 6 3. Maintenance and warranty: Machines are all filled with the Company's original "motor oil' in pump. After a period of operation, please replace the grade "SAE 15W - 40" or equivalent grade 4-stroke motorcycle engine oil with proper amount. After the first 50 hours of working, the crankcase of pressure pump must be cleaned as follows: ①Unscrew the drain screw of pump at first and drain old oil in the crankcase, then reassemble the drain screw to the crankcase...
- Page 7 4. Motor maintenance and repair： 1. Machine should be working in a dry environment. Keep motor surface clean, and air inlet free from blocking of fiber and others. 2. When the motor's thermal protection and short circuit protection occurred in succession, please identify whether it is caused by the motor failure, overload protection device or too low setting value.
Need help?
Do you have a question about the T1 and is the answer not in the manual?
Questions and answers