• Because reissuance is restricted. • Because the part is made to order (at current market price). • Because it is carried in electronic data on the Roland web site. • Because it is a package or an accessory irrelevant to the function maintenance of the main body.
* Printed matters will not be supplied after the end of the production. Then, Indicator download the electronic file from the Roland web site. * In the interest of product improvement, the specifications and/or appearance of CHECK Indicator (Serves also as tempo and battery check indicator) this unit are subject to change without prior notice.
Jun. 2011 BF-3(T) Disassembly Procedure Remove No. 6 Bottom Cover, and No. 7 Insulating Sheet. Lift the Main Sheet Assy. Remove the VR Board (1), and then the OUTPUT B jack (2). fig.bunkai.eps Conversion to the BF-3A When converting from the BF-3 (older type) to the BF-3A (new type), replace the components shown in the following chart. BF-3 BF-3A Part Code...
Jun. 2011 BF-3(T) Parts List fig.-part1-e.eps Due to one or more of the following reasons, Safety Precautions: parts with parts code ******** cannot be supplied as service parts. The parts marked have safety-related characteristics. Use only listed parts for replacement. •...
Jun. 2011 BF-3(T) Verifying the Version Test Mode Turn down all controls completely counterclockwise (to MIN or Items Required MOMENTARY). Hold down the pedal and connect the AC adaptor to the DC IN jack. • AC adaptor (PSA-series device) The CHECK LED lights up and the unit enters the Test Mode. •...
Page 10
Jun. 2011 BF-3(T) 1. DSP and CPU Check 3. CODEC (DAC) Check The DSP and CPU check is carried out automatically. The CHECK LED Set the MODE control to GATE/PAN. lights up green if no problem occurs and flashes red in the event of a Verify that the CHECK LED is lighted up orange.
Page 11
Jun. 2011 BF-3(T) 4. CODEC (ADC) L-channel Check 6. Battery Operation Check Set the MODE control to STANDARD. Set the MODE control to a setting other than MOMENTARY. Verify that the CHECK LED is lighted up red. Connect the stabilized power supply to the DC IN jack, then insert the plug into the GUITAR IN jack.