Page 1
Michi P5 Series 2 Stereo Control Amplifier Préamplificateur Stéréo Stereo-Vorverstärker Preamplificador Estereofónico Stereo-regelversterker Preamplificatore Stereo Stereokontrollförstärkare Предварительный стерео усилитель Owner’s Manual Manuel de l’utilisateur Bedienungsanleitung Manual de Instrucciones Gebruikershandleiding Manuale di istruzioni Instruktionsbok Инструкция пользователя...
Page 2
Michi P5 Series 2 Stereo Control Amplifier Important Safety Instructions Notice The apparatus should be used in non tropical This product shall be connected to a MAINS climate. socket outlet with a protective earthing The RS232 connection should be handled by connection.
Page 3
English Figure 1: Controls and Connections Bedieningselementen en aansluitingen Commandes et Branchements Controlli e connessioni Bedienelemente und Anschlüsse Kontroller och anslutningar Controles y Conexiones Органы управления и разъемы 8 90 - = q w : Source Knob Selects the input signal source. : Display : Volume Knob Adjust the volume output level.
Page 4
Michi P5 Series 2 Stereo Control Amplifier Figure 2: Controls and Connections Bedieningselementen en aansluitingen Commandes et Branchements Controlli e connessioni Bedienelemente und Anschlüsse Kontroller och anslutningar Controles y Conexiones Органы управления и разъемы 8 90 - = q w...
Page 5
English Figure 3: RR-RH6 Remote Control Afstandsbediening RR-RH6 Télécommande infrarouge RR-RH6 Telecomando RR-RH6 Fernbedienung RR-RH6 RR-RH6 fjärrkontroll Mando a Distancia RR-RH6 Пульт ДУ RR-RH6 : Power Button Activate or deactivate the unit. : SETUP Activates the OSD setup screen on the front display. : DISPLAY Button Dims the front display.
Page 6
Michi P5 Series 2 Stereo Control Amplifier Figure 4: Analog Input and Output Connections Branchements des entrées et sorties analogiques Analoge Ein- und Ausgangsanschlüsse Entradas y Salidas Analógicas Analoge ingangen en uitgangen Collegamenti ingressi ed uscite analogici Anslutningar för analoga in- och utgångar Аналоговые...
Page 7
Gebalanceerde ingangen (XLR) en uitgangen Collegamenti ingressi ed uscite bilanciati (XLR) Balanserade in- och utgångar (XLR) Балансные (XLR) входы и выходы Rotel CD Player CLASS 1 LASER PRODUCT APPAREIL LASER DE CLASSE 1 RP-565F Michi P5 Series 2 Michi S5...
Page 8
Michi P5 Series 2 Stereo Control Amplifier Figure 6: Digital Inputs and 12V Trigger Connections Entrées numériques et Branchements des trigger 12 V Digitaleingänge und 12V TRIG Entradas Digitales y Señal de Disparo de 12V Digitale ingangen en 12V trigger Collegamenti ingressi digitali e segnali Trigger 12 V Anslutningar för digitala ingångar och 12-volts styrsignaler...
English Important Notes When making connections be sure to: Turn off all the components in the system before hooking up any components, including loudspeakers. Turn off all components in the system before changing any of the connections to the system. It is also recommended that you: Turn the volume control all the way down before the amplifier is turned on or off.
50 Hz or 60 Hz). The AC line configuration is noted system. If you have any questions see your authorized Michi dealer for advice on a decal on the back panel.
24 bit, 192kHz. streaming via Bluetooth from your device (i.e. mobile phones). From your mobile device, look for “Michi Bluetooth” and connect to it. Connection is Output Connections normally automatic, but if prompted for a password, please press “0000” on your device.
For additional information on the connections, software, and operating codes NOTE: Upon successful installation of the driver, you may need to select for computer control of the P5 Series 2, contact your authorized Michi dealer. the Michi audio driver from the audio/speaker setup of your computer.
To control the power using the IR remote follow the instructions AUDIO above and point the remote control at the Michi products. If a unit does DISPLAY not respond to a power on or off from the IR remote simply PUSH or PUSH- SYSTEM HOLD the power button again to resend the desired command.
English Source Configuration Enabled: Allows a source input to be enabled and appear in the list of source input options when using the source selection on the front panel or IR remote control. Unused sources should be set to disabled by selecting the “No” option. SETUP Options include: Yes(Default), No.
Michi P5 Series 2 Stereo Control Amplifier Renew IP Address: Disabled if Network Type is Static or Disabled. If Network PC-USB Option: Configures PC-USB mode to Audio Class 1.0 or Audio Class Type is DHCP then select Yes and press the Enter button to renew the IP 2.0.
English the Home Theater Bypass select the desired source input connection in the Options include: Disabled (Default), 5 seconds, 10 seconds, 15 seconds. setup menu then select the specified source using the front panel or remote LED Brightness: Sets the brightness of the ON level of the front panel Power LED. control.
Power Indicator still will not light when the P5 Series2 is plugged into the wall outlet, it indicates that the internal power fuse may have blown. If you believe this has happened, contact your authorized Michi dealer to get the fuse replaced.
(19 x 6 x 17 ins.) Front Panel Height Front Panel Height 132 mm, 5 ins. Weight Weight (net) 22.9 kg, 50.5 lb. All specifications are accurate at the time of printing. Michi reserves the right to make improvements without notice.
Page 20
902 McKay Rd. Suite 4 Pickering, ON L1W 3X8 Canada Tel: +1 905-428-2800 Rotel Europe Dale Road Worthing, West Sussex BN11 2BH England Phone: + 44 (0)1903 221 763 Fax: +44 (0)1903 221 525 www.michi-hifi.com Michi P5 Series2 Owner’s Manual Ver N 032823 English...
Need help?
Do you have a question about the P5 2 Series and is the answer not in the manual?
Questions and answers