NETGEAR RAX36S User Manual page 11

Table 1. LED descriptions
LED and Button
Power LED
Internet LED
WiFi LED
Ethernet LED
WPS LED
Hardware Setup
4-Stream AX3000 WiFi 6 Router Model RAX36S
Description
• Solid green. The router is ready.
• Solid amber. The router is starting.
• Blinking amber. The router is not ready, firmware is upgrading, or the Reset button
was pressed.
• Off. Power is not supplied to the router.
• Solid green. The Internet connection is ready.
• Blinking green. The port is sending or receiving traffic.
• Solid amber. An Ethernet cable is connected to the Internet port but Internet is not
accessible.
• Off. No Ethernet cable is connected between the router and the modem.
• Solid green. The WiFi radios are on. You can connect to the router's WiFi network.
• Off. The WiFi radios are turned off and you cannot use WiFi to connect to the router.
• Solid green. The router detected a 1 Gbps link with a device that is connected to
one of the router's Ethernet ports.
• Solid Amber. The router detected a 10/100 Mbps link with a device that is connected
to one of the router's Ethernet ports.
• Blinking green. One of the router's Ethernet ports is sending or receiving traffic at
1 Gbps.
• Blinking amber. One of the router's Ethernet ports is sending or receiving traffic
at 10/100 Mbps.
• Off. No device is connected to an Ethernet port.
Pressing the WPS button on the back of the router lets your WPS-enabled device join
your router's WiFi network without typing the WiFi password. The WPS LED blinks
green during the WPS process and then lights solid green when the WPS-enabled
device connects to your router's WiFi network.
11 User Manual