Advertisement
4. INSTALLATION
4.1.
INSTALLATION FOR TRANSPORTATION
4.1.1.
When used for the transport of motorcycles, the base must be firmly bolted to the floor of a trailer or van.
4.1.2.
If mounting to a trailer or other vehicle, ensure that the floor is strong enough to take the weight of the motorcycle/s plus the tie downs.
4.1.3.
The tie down is secured to the base by means of the four wing bolts and spring washers. When using the chock for
transportation purposes, the front wheel of the motorcycle must be securely strapped to the tie down utilising the strap gap.
4.1.4.
For additional security, consideration should also be given to securing the rear wheel as well.
5. OPERATION
5.1.
To operate the unit, rotate the knobs into the lock position and simply roll or ride your bike into the trailer until your foot pegs hit the
open jaws of the SPL01.
5.2.
Press down on the upper jaws and they will automatically lock into place.
5.3.
Tighten the locking knob
5.4.
To release your bike, simply rotate the knobs into the release position and step on the top jaws. This will automatically release the jaws
and free your motorcycle.
5.5.
For additional safety, insert the attached locking pins prior to transport. You can replace the locking pins with padlocks for added
security and a theft deterrent.
© Jack Sealey Limited
Original Language Version
SPL01 Issue 1 12/12/22
Advertisement
