NCCO DateCodeGenie Lite Quick Start Manual

DateCodeGenie
Printer Setup
1. Attach printer power cord and
printer power supply. Connect to
port on back of printer and to an
outlet.
4. Slide the label roll on core bar
with labels facing forward and
unrolling from left. Snap the core
bar closed.
Lite Quick Start Guide
®
Parts Included
• Printer
• Printer Power Cord
• Printer Power Supply
• Tablet
• Tablet Silicone Cover
• Tablet Micro USB cable
• Tablet USB Power
• Quick Start Guide
• Packing Slip
2. Press the printer power switch
to the - position to turn on printer
and light illuminates green. Pull
forward on both blue/green levers
to open the printer.
5. Feed labels through the blue/
green guides and extend over edge
of printer. Adjust guides to label
width and snap printer lid closed.
(inside tablet box)
Adapter
Scan this QR Code
to watch the
setup video
3. Gently pull the blue/green
core bar from the right side and
extend straight up. Slide the black
line sensor to the far right of the
opening.
6. Press the yellow feed button, as
needed, to align on black line. Pull
down to tear label.
NC DCG 09 002 (4/21)