Related Manuals for Harman JBL Stadium 6
Summary of Contents for Harman JBL Stadium 6
- Page 1 JBL STADIUM 6, STADIUM 8, AND STADIUM 10 MARINE SPEAKER JBL Stadium 6, Stadium 8, and Stadium 10 marine speaker - Owner’s Manual...
-
Page 2: About The Manual
JBL STADIUM 6, STADIUM 8, AND STADIUM 10 MARINE SPEAKER THANK YOU FOR YOUR PURCHASE . . . Your JBL product has been designed to provide you with the performance and ease of operation you would expect from JBL. ABOUT THE MANUAL This manual describes general installation guidelines. - Page 3 Stadium 10 11-5/8” (295.3mm) 9-9/16” (235.6mm) SPEAKER SIGNAL WIRING To send signal to the JBL marine speaker, connect the positive (+) and negative (-) speaker wires to the appropriate speaker outputs of your source unit or amplifier. Be sure to observe proper polarity. SPEAKER LED WIRING To provide power for the LEDs, plug the 24-gauge black (+), blue, green, and red LED wires from the speaker into the included female connector, then run the wires from the female connector to your compatible 12-volt power source or light...
- Page 4 Wire connected to positive Wire connected to Color produced (+12V) terminal negative (-) terminal Green Green Blue Blue Red + Green Yellow Black Red + Blue Purple Blue + Green Aquamarine Red + Blue + Green White APPLYING FOAM SEAL To help seal your installation against water, and to provide an airtight acoustic seal, apply the self-adhesive foam seal to the speaker frame.
- Page 5 REMOVING THE TWEETER FOR SEPARATE MOUNTING (STADIUM 8 ONLY) Use the included 2-pin tool to remove the tweeter from the woofer housing. Place the pins of the tool in the holes of the tweeter grille and rotate 45 degrees clockwise to loosen and remove. FLUSH-MOUNTING THE TWEETER Place the tweeter in the mounting bracket and use the tool to secure by turning 45 degrees counter-clockwise.
-
Page 6: Specifications
Place the tweeter in the mounting location, then turn each setscrew clockwise to tighten mounting brackets. Use caution so as not to overtighten. Snap the included outer ring over the mounting bracket to hide the setscrews. Specifications Stadium 6 Stadium 8 Stadium 10 Continuous power 100W...