Advertisement
Available languages
Available languages
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, these instructions and warnings should always be
followed to reduce the risk of fire, electrical shock and injury to persons:
Read all instructions before using this Fan.
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR PERSONAL INJURY,
WARNING
ALWAYS FOLLOW THESE IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS:
DO NOT use this Fan to ventilate areas where flammable liquids or vapors are used, stored or are present, including paints, gasoline,
varnishes, floor refinishing products or solvents. ALWAYS read and follow all warnings and instructions on the containers for
these products!
ALWAYS be sure the plug fits tightly into the outlet. When plugs fit loosely into outlets, they may slip partially out of the outlet and
create a poor connection. This may cause outlets to overheat and create a potential fire hazard. Outlets in this condition should be
replaced by a qualified electrician.
ALWAYS unplug the power cord when servicing, cleaning or moving the Fan. DO NOT use the ON/OFF switch as the sole means
of disconnecting power. NEVER leave children unattended when the Fan is on or plugged in. ALWAYS turn off and unplug the Fan
when not in use.
BE CERTAIN that the power source for the Fan is 120V AC. DO NOT plug the Fan into 240V or other power source.
The Blue Plug
on your Lasko Fan is a safety feature. It contains a non-replaceable safety device (fuse) that should not be removed
™
or tampered with. To reduce the risk of fire, electric shock and personal injury, DO NOT attempt to remove, replace, repair or tamper
with the originally supplied plug. If the Fan has stopped functioning, it may be due to the safety device incorporated in this plug.
THIS FAN HAS A POLARIZED PLUG (one blade is wider than the other). This plug is designed to fit into the outlet only one way.
Match the wide blade to wide slot in outlet and FULLY INSERT. DO NOT attempt to bypass or defeat this safety feature. If the plug
does not fit in the outlet, consult a qualified electrician. The outlet may need to be replaced.
CAUTION
• AVOID the use of extension cords, power strips, power taps, outlet style air fresheners or other cord connected device, as these devices
may overheat and cause a fire hazard.
• DO NOT route power cord under rugs, carpets, runners or furniture. This may damage the cord or cause it to overheat creating a fire hazard.
• ALWAYS place the Fan on a stable, flat, level surface while in operation to prevent the Fan from overturning.
• NEVER insert or allow fingers or objects to enter grill openings while Fan is in operation or injury and/or damage to the Fan may occur.
• DO NOT block, cover or obstruct air flow to or from the Fan while in operation.
• DO NOT use this Fan outdoors or near water or wet locations such as a bath tub, pool or hot tub. Use of this Fan in a wet location may
create a shock hazard.
• DO NOT run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or
appliances. Arrange cord away from traffic area and where it will not be tripped over.
• NEVER use a single extension cord to operate more than one Fan or other electrical device.
• DO NOT use this Fan if it has been damaged or is not functioning properly.
• Remote controls for other appliances or electronic equipment can sometimes interfere with the operation of this Fan. If this occurs, move
the Fan to another location.
• Keep Fan remote control unit away from chairs and your bed where it may be sat or laid upon and inadvertently turn on the Fan.
• THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008). This Fan is not suitable for use in agricultural
facilities including areas where livestock, poultry or other animals are confined. Please refer to National Electric Code (NEC) Article 547-7
(2008), or applicable state or local codes or standards relating to electrical requirements for agricultural buildings.
• THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 500 (2008). This Fan is not suitable for use in hazardous
locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or local codes or standards relating to electrical
requirements for hazardous locations.
SAVE THESE INSTRUCTIONS
Rev. A 12/22
WARNING
2
Partes Incluidas
1
Cuerpo
1
Control Remoto
2
Tornillos Mariposa
3
Ensamblaje
Base A
1. Alinee las ranuras de la base A con las
lengüetas de la base B. Empújelas
juntas firmemente.
Ensamblaje
4. Pase el cable de
alimentación a través
de la ranura del
sujetacables en la
base del ventilador.
Rev. A 12/22
T36511_T36511ES
Base de Soporte A
4
5
Base de Soporte B
Base B
2. Introduzca el cable eléctrico a través
del orificio grande en el centro de la
montura de la base de apoyo.
Controles
Botón de Encendido
ENCENDIDO/APAGADO
el Ventilador presionando
el Botón de Encendido
Botón de Velocidad
La Velocidad del Ventilador
se puede ajustar a 1, 2, 3, o 4
* Modo oscuro LASKO
Tenga en cuenta que este producto
está habilitado para el modo oscuro.
Las luces de la pantalla se apagarán
automáticamente para crear una
experiencia de usuario
más agradable.
7
3
2
4
5
3. Asegure la Montura de la Base de Apoyo
a la parte inferior del ventilador con (4)
Tornillos de Mariposa.
Botón temporizador
El temporizador se puede
configurar de 1 a 15 horas.
Continúe presionando el botón
del temporizador para alcanzar
el ajuste de tiempo deseado.
La función de temporizador se
desactivará cuando ninguno de
los LED del temporizador esté
iluminado.
Botón de Oscilación
Presione el Botón de Oscilación
para iniciar y detener la función
de oscilación.
T36511_T36511ES
Advertisement
