Download Print this page

Telegesis ETRX2DVKA-Plus Quick Start Manual

Development kit

Telegesis

ETRX2DVKA-Plus Development Kit

Your ETRX2DVKA-Plus contains:

An ETRX2 USB stick

A Development Kit board

An ETRX2HW ZigBee module, to plug on to the Development Kit board

An ETRX2HRHW-PA module, to plug on to the Development Kit board

Two ETRX2MCB module carrier boards

One ETRX2MCB-PA module carrier board

Three battery holders for the module carrier boards

One USB cable

One half-wave antenna with adaptor cable

The ETRX2DVKA-Plus Development Kit has been designed to allow quick

evaluation and prototyping using the ETRX2 wireless mesh networking

modules. The Power Amplifier modules will allow you to test their greater

outdoor range and within-building penetration.

TG-ETRX2DVKA-QS-02-302

Dev Kit Quick Start Guide

Quick Start Guide

3.02

Table of Contents

Need help?

Do you have a question about the ETRX2DVKA-Plus and is the answer not in the manual?

Page 1 One USB cable One half-wave antenna with adaptor cable The ETRX2DVKA-Plus Development Kit has been designed to allow quick evaluation and prototyping using the ETRX2 wireless mesh networking modules. The Power Amplifier modules will allow you to test their greater...
Page 2 USB stick. Then right-click on “My Computer”, select “Manage” and “Device Manager”. Under “Ports” you will see your Telegesis USB device(s); note the COM port number that it is attached to (here, COM5). Now you can close the Device Manager.
Page 3 For instructions on how to use the AT-Commands read the AT Command Manual and the ETRX2 wireless meshing module user guide. After installing the Telegesis Terminal Application program the command buttons for firmware R2xx based on EmberZnet2.x or R3xx based on EmberZnet3.x will be shown at the bottom of the window.
Page 4 ETRX2 into your application. The Telegesis Terminal Application also allows you to create custom command buttons for your individual application, just click on Commands / Add command button…...