Terratrip Tripmeter 101 Operating Instructions

Table of Contents

Download this manual

Normal Operation:

Press 'PWR' button to power on the T101. The screen will show the

Terratrip logo for a short time, whilst the unit initialises. During this time the

T101 will still count distance, so if a stored value of distance is to be used, or

modified, please wait until the display shows the distance before moving the

vehicle to which it is fitted.

Probe in use indicator.

Count Up/ DOWN indicator

Distance display.

Calibrated Units- miles or km.

Display Freeze indicator.

Once the T101 has initialised the display will look like the figure 1. The

centre of the screen displays the distance counter (3) and units (4) that the

units [miles or km] in which the unit has been calibrated.

If the display is frozen, the freeze indicator (5) will appear. This

temporarily halts the display on screen, but the counter will continue to count

in the background.

The Probe indicator (1) shows which probe is in use, or whether the

probes are turned off. The counter direction indicator (2) shows whether the

unit is counting up or down, and if connected the reverse signal controls the

counter direction.

Terratrip 101 Tripmeter.

Operating Instructions.

Manual V1.4: 12/03/2013

Figure 1 - Display Picture – Normal Mode

Table of Contents

Do you have a question about the Tripmeter 101 and is the answer not in the manual?

Page 1 Press ‘PWR’ button to power on the T101. The screen will show the Terratrip logo for a short time, whilst the unit initialises. During this time the T101 will still count distance, so if a stored value of distance is to be used, or modified, please wait until the display shows the distance before moving the vehicle to which it is fitted.
Page 2 Key Function in Normal Mode. Freeze the counter on the screen, the counter will continue counting although the screen is frozen. One the key is pressed a second time the display will show the current distance. Set the distance to a pre-determined value. Once pressed, you can enter a four figure distance using the keypad e.g.
Page 3 Navigate down the menu or decrease the value. Where a slider is shown, holding the key down will automatically decrease the value. Sets or selects the current value or option Exits the menu cancelling all changes and returns to the normal screen.
Page 4 Contrast. Displays current contrast ratio in the form of a horizontal slider. Use the up and down buttons to adjust the contrast / viewing angle of the display. Press ENTER to set, or MENU to cancel. Connections: 1 – Probe 1&2 + 7 –...
Page 5 Remove the inner speedometer cable and cut out 42 mm section from the outer cable. Put the metal sleeves and ring nuts over each end of the outer cable. Push the inner cable through one outer half and then through the sensor. Put the inner cable through the other outer cable;...