Download Print this page

Acmeda AUTOMATE Installation & Programming Instructions

Wind / light detection sensor wired, electronic limit tubular motor, remote control

A U T O M A T E W I N D / L I G H T S E N S O R

I N S T A L L A T I O N & P R O G R A M M I N G I N S T R U C T I O N S

AUTOMATE Wind / Light Detec on Sensor

[Wired]

RF5

RF500 series Remote Control

Electronic Limit Tubular Motor

FEB 2014

Table of Contents

Need help?

Do you have a question about the AUTOMATE and is the answer not in the manual?

Page 1 I N S T A L L A T I O N & P R O G R A M M I N G I N S T R U C T I O N S FEB 2014 AUTOMATE Wind / Light Detec on Sensor [Wired]...
Page 2 I N S T A L L A T I O N O R I E N T A T I O N S The wind and light sensor can be installed in the following orienta ons; I N S T A L L A T I O N I N S T R U C T I O N S STEP 1 R E M O V E T H E T W O S I D E C A P S T O O P E N T H E P O W E R J U N C T I O N B O X .
Page 3 P R O G R A M M I N G W I T H A N R F 5 0 0 S E R I E S R E M O T E STEP 1 P A I R W L S E N S O R W I T H R E M O T E a.
Page 4 W I N D G R A D E P R E F E R E N C E S If the wind speed is over the se ng value for more than 3 seconds, the sensor will close the awning. GRADE WIND SPEED 15 Km/h...