Panasonic WV-Q118 Instructions

FEATURES
The Wall Mount Bracket WV-Q118 is provided for
mounting the Combination Camera WV-CS950 or
WV-CS954 onto the wall.
PRECAUTIONS
• Fasten the bracket to a ceiling strong enough
to support the camera weight (approx. 3
kg.{6.60 lbs}).
• Wipe the bracket regularly using a soft and
dry cloth, or a cloth moistened with a water
solution of an ordinary kitchen detergent.
• Do not use chemicals for cleaning the enclo-
sure as it may damage the surface.
• All the necessary steps required for installing
this product must be taken by a qualified ser-
vice person or system installer.
Wall Mount Bracket
Instructions
WV-Q118/WV-Q118E
Model Nos.
Before attempting to connect or install this product,
please read these instructions carefully and
save this manual for future use.
AM0205-0 3TR003444AAA Printed in Japan
• Be sure to use the Fall Prevention Wire.
• Do not use this bracket with any equipment
other than the WV-CS950 and the WV-CS954.
• Follow all applicable local and national elec-
trical, fire and safety codes when installing
the camera with this ceiling mount bracket.
The model numbers in this Operating Instruc-
tions are shown without suffix.
PLACES OF INSTALLATION
There are various ways of installing the camera as shown below.
● Wall Box
Wall box
● Concrete
Concrete slab
INSTALLATION
1 Make four holes in the wall using the template
(provided).
2 Wrap the camera cables with the Protection
Cover (provided) as appropriate to the
Diecast Case.
3 Remove the Mounting Screw (M3, provided),
pull up the Camera Mounting Base off the
camera, and turn the camera counterclock-
wise.
4 Cut the Diecast Case as shown.
Note: Be sure to protect the Video and Power
Cables with the Protection Cover
( provided ).
● Wood Siding Board
Wood Siding Board
Strong enough to support the
camera weight
(approx. 3 kg {6.60 lbs})
Concrete slab
Wall
Template
(provided)
Protection Cover
(provided)
Part to be cut
Mounting
Screw
15°
Rotate
Remove the Camera Mounting
Base by pulling up.
Cut here