Strong FS Series Product Data Sheet

Product Data Sheet
FS SERIES
Fully Assembled Rack System w/ DC Fans
SR-FS-SYSTEM-DC- 15U / 21U / 27U
Product Overview
Package Contents
A. Top Cover
B. Frame
C. Front Door - Tinted Glass
D. Side Panel (x2)
E. Rear Panel
F. Bottom Cover
G. 2U Rack Shelf (varies per rack units)
H. 2U Vented Panel (varies per rack units)
I. Casters (x4)
J. DC Fans (x2)
K. Locking Door Latch
L. Door Latch Plate
M. Ground Studs (4) (located on top and bottom
covers in the rear of rack)
N. Nylon Washers (3)
O. Pre-installed Bushings (3) (located inside
hinge holes)
Key Features
• 750 lbs. Max Load Capacity
• Tamper Resistant Lock on Reversible
Tempered Glass Front Door
• Removable Side and Rear Panels for Easy
Serviceability
• Front and Rear Rails Tapped with 10/32
Threads to Allow for Mounting of Components
in Front or Rear of Rack
• Superb Ventilation System - Strategically
Placed Fans* & Vents to Ensure that Equip-
ment Stays Cool
• Lifetime Limited Warranty
Included Accessories
Each rack includes the following number of shelves
and vent panels.
Rack Shelves
SR-FS-SYSTEM-DC-15U
SR-FS-SYSTEM-DC-21U
SR-FS-SYSTEM-DC-27U
*Notes: Fans are always on, we recommend they are
plugged into a switching surge protector or AV
receiver.
Please be sure to check with local authorities in
regard to code requirements for compliance.
If the door is rubbing against the base, then add the
necessary amount of nylon washers (N) onto the
bottom hinge pin to allow for extra clearance.
Vented Panels
2 2
3 3
5 5
CAUTION!
When loading equipment into cabinet, ensure that the
casters are locked, and load heavier equipment at the
bottom of the rack.
Reversing Front Door
Tools Required:
#2 Phillips Head Screwdriver
Reversal Steps
1. Remove both side panels (D), and open the front door (C).
2. Remove the Door Latch (K) by removing the clamp with a
#2 Phillips screwdriver, and slide the latch out of the door.
3. Remove the Latch Plate (L) using a #2 Phillips screw-
driver.
4. Pull the top and bottom hinge pins out of the locking
position and slide the door up and out. Remove the
bottom, pre-installed bushing (O).
5. Insert the bushing into the opposite bottom hinge pin hole.
6. Flip the door over, and slide the bottom hinge pin in first.
Once in place, insert the top hinge pin. Ensure hinge pins
are secure.
7. Attach the Latch Plate (L) to the rack opposite the door
hinges using a #2 Phillips screwdriver.
8. Insert the Door Latch (K) into the door, and secure with the
clamp using a #2 Phillips screwdriver.
9. Close and latch the door, and reattach the side panels (D).
© 2017 Strong Racks Rev: 170321-0836
TM