Blue Mark DB120 Quick Start

QUICK START DB120
(rev 20230418)
Attach to the drone
Attach the db120 on the top of
your drone:
Use the 3M dual lock™

stickers (included).
And/or use two M5 screws.

Use the db120
Power on the db120.

Wait for Status LEDs to

signal Ready for take-off.
You are ready to fly.

Status LEDs
e e l e e l e e
Ready for take-off: slowly
flashing (every 4s), location acq.
e e l e e l e e
Non-compliant config: very slow
flashing (every 20s), location acq.
e e l e e l e e
Acquiring location
Charging
Charge
Charge the db120 using a USB-C
Charge the db120 using a USB-C
charger. Charging LED turns green
charger. Charging LED turns
if fully charged.
green if fully charged.
Configuration
Configuration
No configuration is required for
USA. Configure operator ID for EU
No configuration is required for
use.
USA. Press configuration button
and connect to dronebeacon
Press configuration button and
WLAN network. Point your
connect to dronebeacon WLAN
browser to http://192.168.50.1
network. Point your browser to
http://192.168.50.1