Advertisement
Quick Links
Advertisement
Summary of Contents for FOCO Standard container
- Page 1 ASSEMBLY INSTRUCTIONS Standard container...
- Page 2 Equipment - Screwdriver or drill (Phillips head) - 13 mm wrench - 19 mm wrench - Torque wrench (13 mm and 19 mm inserts) Manual: First, using the 19 mm and 13 mm wrenches, remove the screws that hold the floor and roof package to- gether, save these screws.
- Page 3 Then the panels are removed from the package, do not place them on the asphalt this can cause dama- ge in the form of dents or scratches. Protect the panels with leftover wood or plastic from the package. Always mount a container on a straight level surface. Next, the panels are placed in the correct position (photo above).
- Page 4 Then the two panels are mounted using a 13mm screw, a nut and two washers. The screw is fixed with the nut in the holes with a washer on both sides for protection. Each corner of a container contains three fixing holes where a screw must be placed. Using the key, the cylinder lock is attached (photo 1).
- Page 5 The roof must be placed with (at least) two people, for larger models more people are required. As seen in the pictures above, the roof is slid onto the sliding rails at the top of the container. The roof is correctly placed when it falls into the slots.