1. General Description The 17WFM21 WI-FI module design is a highly integrated MIMO wireless LAN (WLAN) used for high speed wireless local network access. The card is built with 2T2R capable RF/baseband single chip. The 17WFM21 WI-FI module design implements multiple input, multiple output (MIMO) orthogonal frequency division multiplexing (OFDM) with 2 transmit and 2 receive paths and is compatible with 802.11 a/b/g/n specifications.
5G HT40 Ch64, TX mode current wave form (VCC 5V) 4.3. Thermal characteristics Operating temperature is 65 degree. Tj max 125 degree for wifi chip. 5. RF Characteristic 5.1 Wi-Fi Typical power levels for wi-fi radio are given in figure below. 2.4G BAND Standard 802.11b...
11. Hardware & Software installation 11.1. Hardware Installation 17WFM21 module is a build in module. It will be used in-house production as an embedded device over USB 2.0 interface and there is no need any interaction with end-user. Positioning of the module is defined by assembly operator instructions for each product by Vestel.
The module 17WFM21 has been tested and approved as a Modular Radio in accordance with the appropriate FCC and IC standards. The supporting test data may be found in the modular test report.
2. L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. 13. Country Regulations Device is intended for home and office use in all countries and countries may have their own regulations to prohibit some wlan frequencies. Proper country information must be selected from UI during first time boot up settings.
Page 9
Below steps must been followed for testing Rx on module.
Need help?
Do you have a question about the 17WFM21 and is the answer not in the manual?
Questions and answers