Table of Contents
Advertisement
S
I
/U
AFETY
NFORMATION
SEFUL
Safety
Disconnect mains plug when :
– the red light below the TV screen is flashing continuously.
– a bright white line is displayed across the screen.
– cleaning the TV screen. Never use abrasive cleaning agents. Use a slight damp chamois
leather or soft cloth.
– there is a lightning storm.
– the set is left unattended for a prolonged period of time.
Useful Tips
• Do not place your TV set under direct sunlight or heat.
• Avoid placing your set (e.g. near the window) where it is likely to be exposed to rain
or water.
• Do not leave your set on standby mode for a prolonged period of time. Switch off set
to allow it to be demagnetised. A demagnetised set supports good picture quality.
• Do not shift or move the set around when it is switched on. Uneveness in colour in
some parts of the screen may occur.
• Never attempt to repair a defective TV yourself. Always consult a skilled service personnel.
B
C
EFORE
ALLING
Below is a list of frequently occurred symptoms. Before you call for dservice, make these simple
checks. Some of these symptoms can easily be rectified if you know what to do.
Symptom
What you should do
Colour patch
• Switch off the TV by the mains power button. Wait for 20
(uneveness)
minutes before switching on again.
• Check the TV is not placed too near speakers or magnetic
objects.
No power
• Check the TV's AC power cord is plugged into the mains
socket. If there is still no power, disconnect plug. Wait for
60 seconds and re-insert plug. Switch on the TV again.
No picture
• Check the antenna connection at the rear of the TV.
• Possible TV station problem. Try another channel.
Good picture
• Try increasing the volume.
but no sound
• Check that the sound is not muted. If it is muted, press the
(mute) button on the remote control to restore sound.
H
H
H
H
H
Good sound but poor
• Try increasing the contrast and brightness setting.
colour or no picture
Snowish picture and
• Check antenna connection at the rear of the TV.
noise
Horizontal dotted lines
• Possible electrical interference e.g. hairdryer, vacuum
cleaner, etc. Switch off appliances.
Double images or
• Possible poor positioning of antenna. Using a highly
"Ghost" images
directional antenna may improve reception.
TV not responding to
• Check life span of batteries of remote control handset.
remote control handset
• Aim remote control handset directly at remote control
sensor lens on the TV.
3
T
IPS
S
ERVICE
I
NSTALLATION
Positioning of the TV set
5 cm
• Place your TV set on a solid base, strong enough to
withstand the weight of the set.
5 cm
5 cm
Ñ
É
Ñ
É
• Leave a space of at least 5 cmaround each side of the
TV set to allow for proper ventilation.
• Do not place TV set near a radiator or other sources of
heat.
• Do not place TV set where it can be exposed to rain or
excesssive moisture.
Connecting the Aerial
• Insert the aerial plug into the socket ¬ at the rear of
the set.
Connecting to the mains
• Insert the mains plug into the wall socket. (For correct
mains voltage, refer to the type sticker at the rear of the
set).
Note : This diagram is not representative of the actual
plug and socket.
Using the Remote Control
• Insert the correct type of batteries into the compartment.
• Ensure the batteries are placed in the right direction.
Note : Remove the batteries from the remote
control handset if handset is not used for a long time.
Switching on the TV set
• Press the mains power button to switch on/off the TV set.
• If the set is on standby mode (indicator light is red), press
the Standby button on the remote control to switch on set.
4
Advertisement
Table of Contents
