Page 1
Speaker Floor Stand Instruction Manual V5.0 /Modèle Model : PSSS2 English ------------------------ 01-05 Français ------------------------ 06-10 Thank you for choosing this PERLESMITH product! At PERLESMITH we strive to provide you with the best quality products and services in the industry. Should you have any issues, please don't hesitate to contact us at...
IMPORTANT SAFETY INSTRUCTIONS •Check package contents against Supplied Parts and Hardware List to assure that all components were received undamaged. Do not use damaged or defective parts. lf you require replacement parts, please contact customer service at supportus@perlesmith.com. •Carefully read all instructions before attempting installation. If you do not understand the instructions or have any concerns or questions, please contact our customer service at supportus@perlesmith.com.
Page 3
STEP 1 Secure the Feet and Support Posts to the Base...
Page 4
STEP 2 Secure the Speaker Bracket to the Upper Support Post 19/32 in-13 25/32 in (15-350 mm)
Page 5
STEP 3 Secure the Speaker to the Stand and Tilt Adjustment 5 29/32 in-10 53/64 in (150-275 mm) Loosen...
Page 6
Note: The speaker must be installed on the middle of the speaker bracket. Speaker (not included) Tighten Tighten 360 Degree All-round Tilt Adjustment If needed, the speaker angle can be adjusted. 1. Remove the speaker from the stand. 2. Slightly loosen the bolt [E]. 3.
Consignes de sécurité importantes •Vérifier le contenu de l'emballage par rapport à la liste des pièces et du matériel fournis pour vous assurer que tous les composants ont été reçus sans dommage. Do not use damaged or defective parts. Si vous avez besoin de pièces de rechange, veuillez contacter notre service clientèle à...
Page 8
STEP 1 Fixer les pieds et les poteaux de soutien à la base...
Page 9
Fixer le support de l'enceinte au poteau de support Étape 2 supérieur 19/32 pouces - 13 25/32 pouces (15-350 mm)
Page 10
Étape 3 Fixer l'enceinte au support et au réglage d'inclinaison 5 29/32 pouces-10 53/64 pouces (150-275 mm) Desserrez...
Page 11
Remarque : L'enceinte doit être installée au milieu du support d'enceinte. Enceinte (non inclus) Tighten Serrer Réglage de l'inclinaison sur 360 degrés Si nécessaire, l'angle de l'enceinte peut être réglé. 1. Retirer l'enceinte du support. 2. Desserrer légèrement le boulon [E]. 3.
Page 12
Thank you again for choosing this PERLESMITH product! All of us at PERLESMITH do appreciate your product purchase. We hope that you are as happy with your product as we designing and manufacturing it for you. We strive to provide you with the best quality products and services in the industry.