Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Norris FI 700
- Page 1 Norris Upright Dishwasher FI 700/750 Operation Manual Rev No. 3 23/03/2023...
-
Page 2: Table Of Contents
Contents INTRODUCTION ......................2 INSTALLATION ......................3 2.1 Requirements ......................3 2.2 Positioning & Connecting ..................4 2.3 Screen and Dial .....................5 2.4 Water Levels ......................5 2.5 Priming Boiler ......................5 2.6 Priming New Rinse and Detergent Lines ...............5 OPERATION .........................6 3.1 General Operation and Safety Instructions ............6 3.2 Start of Day Operation ...................7 3.3 General Operation ....................8 3.4 End of Day Drain and Shutdown ................9... -
Page 3: Introduction
We have grown from humble beginnings into our current headquarters and manufacturing plant located in Caves Beach, NSW. Norris believes that “We would like to leave the world a better place than when we found it”, a philosophy that requires constant innovation and keeps sustainability at the forefront of our business practices. -
Page 4: Installation
Water pressure requirements are: 10 L/min at 200-400 kPa max. Higher water pressure can cause damage to the machine which may void warranties, please contact Norris for more information. Drain Connection Drain connection point within 1 metre of the machine. The hot water Point discharge rate is approximately 16 L/min at up to 65ᵒc. -
Page 5: Positioning & Connecting
2.2 Positioning & Connecting Step Action Warning: Risk of electric shock. Failure to connect properly to the power supply can cause mortal danger from electric shock. (Have the machine connected to the power supply by an authorised technician according to the local and national codes. For Australia: in accordance with AS/NZS3500.1) Position and Level Your Machine Fit adjustable feet to the underside of the machine. -
Page 6: Screen And Dial
2.6 Priming New Rinse and Detergent Lines Norris recommends that you prime the chemical lines before you run the machine for the first time or are connecting new chemical containers in order to remove all air from the lines. -
Page 7: Operation
3.1 General Operation and Safety Instructions • Carefully read through the safety and operating notes contained in these instructions. Norris will not accept any liability and all warranty claims will be rendered null and void if the safety notes are not observed. -
Page 8: Start Of Day Operation
3.2 Start of Day Operation Step Action Illustration Open the Hood Remove Rack Slide Replace Filter Covers & Scrap Trays Replace Rack Slide Close the Hood and turn Selector Dial to FILL The machine will fill the wash chamber with water. Note: Closing the hood starts the operation... -
Page 9: General Operation
3.3 General Operation Step Action Illustration Open the hood and insert rack 82.5 Turn the Selector Dial to CYCLE To start the cycle: Close the Hood. The cycle will always start once the hood is fully closed. The machine will automatically complete its rinse cycle once correct temperature has been... -
Page 10: End Of Day Drain And Shutdown
3.4 End of Day Drain and Shutdown Step Action Notes Open the Hood and remove excess debris. Turn the Selector Dial to Drain When all the water is drained away and wash tank is empty, turn the 82.5 Selector Dial to OFF Machine must be turned OFF. -
Page 11: Maintenance
4 MAINTENANCE Norris recommends carrying out appropriate daily and weekly maintenance on the machine to keep it in working order. • Wear protective clothing and protective gloves before touching any parts which are covered with a detergent solution (filters, wash fields etc.). -
Page 12: Machine Information
° C. 5.2 Detergent & Rinse Aid This Norris Dishwasher model has external detergent and rinse aid pumps and these are set in accordance with pump instructions. A commercial liquid, non-foaming dishwashing detergent must be used in accordance with the chemical manufacturer’s recommendations. -
Page 13: Troubleshooting & Error Messages
Blocked Wash Jets Remove the Wash Arms and clean Temperature is too low Allow wash water to heat up Faulty Dosing Pump or Technical Contact Norris Error Too much detergent Reduce amount of detergent used Dishes are still Incorrect detergent has been... -
Page 14: Safety
• detergent solution. • Norris Industries will not accept liability for any damage caused by failure to use the dishwashing machine in accordance with the intended use. 7.3 Handling Chemicals Most warewashing chemicals are highly corrosive. When using chemicals, adhere to the safety •... -
Page 15: Disposal
Machines are made from high-quality stainless steel and recyclable plastics. Please contact your local council or tip for the best place to dispose of your machine. A Norris machine is designed to last a long time. Before disposal, we strongly recommend you consider refurbishment. Contact Norris for further assistance. -
Page 16: Warranty Terms And Conditions
All Norris, Australian Manufactured Glass and Dishwashers come with a two (2) year parts & labour warranty as set out below. This warranty is given by Norris Industries Pty Ltd, hereinafter referred to as Norris, ABN 69 002 351 840, of 28 Strathmore Road, Caves Beach, NSW, Australia, the manufacturer of Norris brand Glasswashers and Dishwashers (the appliance) and shall only apply to appliances installed in premises within the Commonwealth of Australia. - Page 17 Norris. Use of replacement parts not supplied by Norris or the use of labour not being that of an authorised Norris technician shall relieve Norris of all future liability and responsibility.
- Page 18 SERVICE NOTES: Page 17 of 19...
- Page 19 SERVICE NOTES: Page 18 of 19...
- Page 20 Page 19 of 19...