Advertisement
Available languages
Available languages
Assembly
Mount the line spool on your edge trimmer as usual. If you place the line spool
firmly on the ground with the green button while the trimmer is running, some
line will automatically be released.
When the thread is used up, press the green button and turn it against the
direction of the arrow until the arrow markings are on a line and the remainder
of the thread can be easily pulled out of the spool. Make sure you can see
through the thread channel from the side and thread the new thread through
the bobbin. The thread should protrude equally far out of the spool on both
sides.
Turn the green knob in the direction of the arrow to pull the thread into the
spool the thread ends protrude from the bobbin for a sufficient length of time
so that you can operate the trimmer.
Cleaning
Remove grass and other vegetation that is wrapped around the spool to
avoid overloading the drive.
To avoid damaging the surface, do not use harsh chemicals or abrasive
cleaners to clean the bobbin.
Technical Data
Thread:
Flange:
Dimensions:
Weight:
Dear Customers,
Instruction manuals provide valuable hints for using your new device. They
enable you to use all functions, and they help you avoid misunderstandings and
prevent damage. Please take the time to read this manual carefully and keep it
for future reference.
If you pass the device on to third parties, enclose these instructions.
Operation
approx. 2 m length, Ø 2.4 mm
M10
approx. Ø 130 x 80 mm
approx. 450 g
3
Advertisement
