Installing The Sata Raid/Ahci Driver And Operating System - Gigabyte GA-F2A85XN-WIFI User Manual

3-2

Installing the SATA RAID/AHCI Driver and Operating System

With the correct BIOS settings, you are ready to install the operating system.
A. Installing Windows 8/7
(The following instructions use Windows 8 as the example operating system.)
Step 1:
You need to install the SATA RAID/AHCI driver during the OS installation. Use an alternative system to copy
the SATA RAID/AHCI driver from the motherboard driver disk to a USB flash drive. Copy the Hw8 folder under
BootDrv in the driver disk.
Step 2:
Boot from the Windows 8 setup disk and perform standard OS installation steps. When the screen requesting
you to load the driver appears, select Browse.
Step 3:
Then browse to the USB flash drive and select the location of the driver. The locations of the drivers are as follows:
RAID driver for Windows 8 32-bit: Hw8\RAID\x86
RAID driver for Windows 8 64-bit: Hw8\RAID\x64
AHCI driver for Windows 8 32-bit: Hw8\AHCI\W8
AHCI driver for Windows 8 64-bit: Hw8\AHCI\W864A
For Windows 7, browse to the Hw7 folder.
Step 4:
When a screen as shown in Figure 1 appears, select AMD AHCI Compatible RAID Controller and click Next
to load the driver and continue the OS installation.
Figure 1
- 63 - Drivers Installation