Sony XR-75X90L Reference Manual page 2

Note
Troubleshooting
• Instructions about "Installing the TV to the Wall"
are included within this TV's instruction manual. General troubleshooting for issues like: black
• Read the supplied safety documentation for screen, no sound, frozen picture, TV does not
additional safety information. respond, or network is lost, do the following steps.
1
Location of the identification label Restart your TV by pressing the power button
Labels for the TV Model No. and Power Supply on the remote control for about five seconds.
The TV will restart. If the TV does not recover, try
rating are located on the rear of the TV.
unplugging the AC power cord (mains lead)
This receiver complies with the minimum then press the power button on the TV and
requirements as specified in National release it. Wait for two minutes, and plug in the
Telecommunications Commission, AC power cord (mains lead).
Memorandum Circular 02-03-2016, Regarding Or, press the power button on the TV for about
the Sale and Labeling of ISDB-T Receivers, 40 seconds until the TV turns off.
including Memorandum Circular No. 2
Refer to the Help menu shown below.
01-0302017, Amending Certain Provisions of
3
Connect your TV to the Internet and perform a
Section 2 of NTC Memorandum Circular No.
software update. Sony recommends you to
02-03-2016 (Sale and Labeling of ISDB-T
keep your TV software updated. Software
Receivers).
updates provide new features and performance
improvements.
Installing the TV to the Wall
4
Visit Sony support website (information
Using the optional Wall-Mount Bracket (SU-WL850 or provided at the end of the supplied safety
documentation).
SU-WL450)* (not supplied)
When you plug in the TV, the TV may not be
To Customers:
able to turn on for a while even if you press
For product protection and safety reasons, Sony
the power button on the remote control or
strongly recommends that installation of your TV
be performed by Sony dealers or licensed the TV.
contractors. Do not attempt to install it yourself. It takes time to initialize the system. Wait for about
one minute, then operate it again.
To Sony Dealers and Contractors:
The remote control does not function.
Provide full attention to safety during the
installation, periodic maintenance and • Replace the batteries.
examination of this product.
The parental lock password has been
Wall-Mount Bracket Installation Information forgotten.
For instructions on Wall-Mount Bracket installation, • Enter 4357 for the PIN and enter the new PIN.
see the Installation Information (Wall-Mount
Bracket) on the product page for your TV model.
https://www.sony-asia.com/support
• Follow the instruction guide provided with the
Wall-Mount Bracket for your model. Sufficient
expertise is required in installing this TV,
especially to determine the strength of the wall
for withstanding the TV's weight.
• Sony is not liable for any damage or injury caused
Specifications
by mishandling or improper installation.
System
• Only qualified service personnel should carry out
wall-mount installations. Panel system
• For safety reasons, it is strongly recommended LCD (Liquid Crystal Display) Panel, LED Backlight
that you use Sony accessories, including: TV system
— Wall-Mount Bracket SU-WL850 Analog: M
— Wall-Mount Bracket SU-WL450 Digital: ISDB-T
• Be sure to use the screws supplied with the Color system
TV when attaching the Wall-Mount Bracket to NTSC/PAL N (Video Only)/PAL M (Video Only)
the TV set (SU-WL850 only). Be sure to use the Channel coverage
screws supplied with the Wall-Mount Bracket Analog: UHF/VHF/Cable
when attaching the Wall-Mount Bracket to the Digital: UHF/VHF
TV set (except SU-WL850). The supplied screws Sound output (W)
are designed as indicated by illustration when 10 + 10 + 5 + 5
measured from the attaching surface of the Wall- Wireless technology
Mount Bracket. Protocol IEEE 802.11a/b/g/n/ac
The diameter and length of the screws differ Bluetooth® Version 4.2
depending on the Wall-Mount Bracket model.
Input/Output jacks
Use of screws other than those supplied may
Antenna (aerial)/cable
result in internal damage to the TV set or cause
75 ohm external terminal for VHF/UHF
it to fall, etc.
HDMI IN 1/2/3/4 (HDCP 2.3-compatible)
• Be sure to store the unused screws and Table-Top
Video:
Stand in a safe place until you are ready to attach
4096 × 2160p (50, 60 Hz)*
the Table-Top Stand. Keep the screws away from
(24 Hz)*
small children.
(24, 25, 30 Hz), 1080p (24, 30, 50, 60, 100, 120 Hz),
* Only for limited region/country/model. 1080i (50, 60 Hz), 720p (24, 30, 50, 60 Hz), 576p,
480p, PC Formats*
3840 × 2160p (100, 120 Hz)*
Audio:
In eARC (Enhanced Audio Return Channel) mode
Refer to the online Help Guide for details.
Except eARC mode
5.1 channel linear PCM: 32/44.1/48/88.2/96/
176.4/192 kHz 16/20/24 bits, Dolby Audio,
Dolby Atmos, DTS
eARC/ARC (Enhanced Audio Return Channel/
Audio Return Channel) (HDMI IN 3 only)*
In eARC mode
Refer to the online Help Guide for details.
In ARC mode
Two channel linear PCM: 48 kHz 16 bits, Dolby
Audio, Dolby Atmos, DTS
DIGITAL AUDIO OUT (OPTICAL)
Digital optical jack (Two channel linear PCM:
48 kHz 16 bits, Dolby Audio, DTS)
1, 2
USB port 1 supports High Speed USB (USB 2.0)
USB port 2 supports Super Speed USB (USB 3.2
Gen 1)
LAN
10BASE-T/100BASE-TX connector (Depending on
the operating environment of the network,
connection speed may differ. The communication
rate and quality are not guaranteed.)
Power and others
Power requirements
220 V - 240 V AC, 50/60 Hz
Screen size (measured diagonally) (Approx.)
(inches/cm)
XR-75X90L: 75 / 189.3
XR-65X90L: 65 / 163.9
XR-55X90L: 55 / 138.8
Power consumption
Indicated on the rear of the TV
Standby power consumption*
0.5
Display resolution (horizontal × vertical) (pixels)
3840 × 2160
Output rating
500 mA (for USB 1), 900 mA (for USB 2)
Others
Optional accessories
Wall-Mount Bracket: SU-WL850, SU-WL450
For more information, refer to
Camera and Microphone Unit: CMU-BC1
the Help Guide.
Operating temperature
Press (Input select) on the
0 ºC – 40 ºC
remote control and select [Help].
*1 When 4096 × 2160p is input and [Wide mode]
If [Help] does not exist, select
is set to [Normal], the resolution is displayed as
[Edit] and add [Help].
3840 × 2160p. To display 4096 × 2160p, set [Wide
mode] setting to [Full 1] or [Full 2].
*2 Refer to the on screen menu to set [HDMI signal
format].
*3 Refer to the online Help Guide for details.
*4 HDMI IN 3 and 4 only. Use the Ultra High Speed
HDMI Cable to connect.
*5 Connect your audio system to the HDMI IN 3 to
route TV audio to your audio system.
*6 Specified standby power is reached after the TV
finishes necessary internal processes.
*7 Standby power consumption will increase when
your TV is connected to the network.
Note
• Support belt kit
Philippines.
• Optional accessories availability depends on
countries/region/TV model/stock.
• Design and specifications are subject to change
without notice.
• Subscriptions for services and applications may
be required and additional terms, conditions
and/or charges may apply when using Google
Assistant.
• Power consumption will increase when the
1 * 2 , 4096 × 2160p
, 3840 × 2160p (50, 60 Hz)* , 3840 × 2160p built-in MIC is enabled as it is always listening.
1 2
• Visit Sony website for more information on
product specifications.
3
Trademark Information
*
2 4
• Dolby, Dolby Vision, Dolby Atmos, Dolby Audio,
and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
Manufactured under license from Dolby
Laboratories. Confidential unpublished works.
Copyright © 1992-2022 Dolby Laboratories. All
rights reserved.
• Gracenote, the Gracenote logo and logotype,
"Powered by Gracenote" logo are either
5
registered trademarks or trademarks of
Gracenote, Inc. in the United States and/or other
countries.
• For DTS patents, see http://patents.dts.com.
Manufactured under license from DTS, Inc. DTS,
Digital Surround, and the DTS logo are registered
trademarks or trademarks of DTS, Inc. in the
United States and other countries. © 2020 DTS,
Inc. ALL RIGHTS RESERVED.
• TUXERA is a registered trademark of Tuxera Inc. in
the US and other countries.
6 * 7 (W)
FB
is not supplied to