Table of Contents
Advertisement
Step Three: Connect to battery or 12V DC supply.
Batteries are hazardous because they contain caustic acid, can emit explosive
gases, and can cause electric shock.
Caution must be exercised when making connections to a battery to avoid shock
and contact with the acid, and to prevent any sparking that could lead to an
explosion.
ALWAYS follow the safety instructions and steps listed below in exact sequence
when connecting the sprayer's wire harness to the battery terminals.
1. Preparatory safety
2. Electrical
requirements
3. Connect pump to
battery
Assembly
WARNING
Preparatory safety steps:
•
ALWAYS use eye protection.
•
NEVER smoke or work near sparks or other sources of ignition.
•
NEVER touch both battery terminals at the same time or with any non-
insulated tools.
•
If battery acid contacts skin or clothing, flush immediately with water and
neutralize with baking soda.
•
The pump should be on a dedicated (individual) circuit. Do not use wires
longer than those provided in the kit.
•
The pump is protected with a fuse. Use an approved wire of the size specified
or heavier.
Voltage
12V DC 1572210
12V DC 1572212
12V DC 1572213
Connect the pump to a 12V DC battery using the following procedure:
a) Disconnect the vehicle battery ground wire.
b) Connect the pump's red wire to the positive (+) terminal of the battery.
c) Connect the pump's black wire to the negative (-) terminal of the battery.
d) Reconnect the vehicle battery ground wire.
Note: Skip steps (a) and (d) if battery is not in a vehicle.
WARNING: Always connect in this sequence to avoid possible shock.
(black wire)
Model
Fuse (amp)
15.0
15.0
20.0
Negative
12
Fuse Type
Mini blade
Mini blade
Mini blade
Positive
(red wire)
Advertisement
Table of Contents
