Table of Contents
Advertisement
Quick Links
Instruction Manual
Quick-Out
Carabiner
Version 04/2023
Button securing sleeve left
HKar122
Axle for riser
+ axle sleeve
HKar126
+ HKar127
Release button at
installation slot
HKar123L
Special screws for
release buttons
HKar1231
Carabiner body
HKar120
The Quick-Out carabiner is a connecting link that allows quick separation of straps while they are under load. It is suitable for safely attaching
loads, especially people, and is designed for outdoor use.
Breaking load: 4,000 DaN (1 DaN corresponds to approx. 1 kg)
Safe load: 2,000 DaN (individually tested to 2,000 DaN) / 400 DaN (under continuous vibration stress)
Bearing
Intended use
Operating limitations
Red marking dots
Button securing sleeve right
HKar122
Quick-Out insert
HKar121
Button spring
+ sleeve
HKar124
+ HKar125
Release button opposite
installation slot
HKar123R
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Finsterwalder Charly HKar12
- Page 1 Red marking dots Button securing sleeve left Bearing HKar122 Button securing sleeve right HKar122 Axle for riser + axle sleeve HKar126 Instruction Manual + HKar127 Quick-Out insert Quick-Out HKar121 Release button at installation slot Carabiner HKar123L Button spring + sleeve HKar124 Special screws for + HKar125...
- Page 2 The Quick-Out carabiner has to be considered an integral part of the harness and must be installed by a technically trained person in Overview: Quick-Out with speed accordance with the harness manufacturer’s instructions using the current Quick-Out instruction manual (available at www.finsterwalder- system separation link charly.de).
- Page 3 If the Quick-Out does not disengage under load, despite pressing the release buttons on both sides, this may be due to the following reasons: ! DANGER ! The button securing sleeves are not at the same height. • The insert is prevented from tipping out. Instruction Manual | FINSTERWALDER Quick-Out Carabiner | Version 04/2023...
- Page 4 If there is too much resistance, apply a little LIQUI MOLY Schmierfix 1080 to the guide grooves. If the button securing sleeves are too loose, they must be replaced. Lever them out and remove them with a screwdriver (or similar). Finsterwalder GmbH Charly Produkte Pagodenburgstr.
Need help?
Do you have a question about the Charly HKar12 and is the answer not in the manual?
Questions and answers