Advertisement
Quick Links
Advertisement
Summary of Contents for FOCO Office-Container
- Page 1 ASSEMBLY INSTRUCTIONS Office-Container...
-
Page 2: Tools Needed
Tools needed - Screwdriver or drill (Phillips head) - 13 mm wrench - 19 mm wrench - Torque wrench (13 mm and 19 mm attachments) Assembly Manual: First, using the 19 mm and 13 mm wrenches, remove the screws holding the floor and roof package together, save these screws. - Page 3 Next, remove the panels and materials from the package. Do not place them on the asphalt. This may cause damage in the form of dents or scratches. Lay the materials down very gently on level ground. Always assemble a quick build office on a straight level surface. Note that there are short and long panels.
- Page 4 In the picture above, you can see that on the short side, two long panels are placed. On the long side you can see two short panels, and from then in the middle two long panels, so you connect these to the corner profiles.
- Page 5 Before the roof can be installed, the roof profiles must be mounted on the panels. Four pieces for four sides. Roof placement varies by model. For two-by-two meter units, two adults can lift the roof. For three and four meter offices, we recommend lifting with at least four people. 0031 85 0685 590 info@fococontainers.com www.fococontainers.com...
- Page 6 After the roof is in place, lifting hinges are mounted to each corner of the roof panel. A screwdriver can be used to attach the door and window handle. The door handle must be screwed on both sides with screws. Then the supplied cap can be put on and the door handle is mounted. The window handle is mounted in the same way.
- Page 7 Who we are We are FOCO® Containers, we are a company specialized in solutions to storage problems. We have been working for about 10 years to provide everyone with the right container for their needs. We have grown into an international name and currently we are active in several countries throughout Europe.