Related Manuals for Liquid Force TENSION
Summary of Contents for Liquid Force TENSION
- Page 1 TENSION 4-Line Kite Manual Warnings and safety precautions Read the following points before assembling your kite...
- Page 2 11 Warranty Policy 1)Never touch the flying lines when the kite is in use. Flying lines are extremely sharp while under tension and can cause serious injury or death. 2)Never use this product with worn lines. A line that breaks while under tension can cause serious injury or death.
- Page 3 6)The wrist leash system is not a permanent attachment to this breach of contract on the part of liquid force kiteboards, or any of its product. Never permanently attach yourself to the kite or any of agents, in the design or manufacture of this product.
- Page 4 Back Centerline Attachment Point -Needs less bar pressure to turn -Kite is less sensitive to bar position -More Power goes to the spreader bar Carbon Bar Harness line Trimmer Loop Leash Spreader Bar attachment buckle Liquid Force Tension User Guide 04...
- Page 5 Warning: Never use a Liquid Force kite without a wrist leash system. A loose kite is extremely dangerous for anyone downwind of you. Liquid Force Tension User Guide 05...
- Page 6 -Yellow to Yellow -Yellow to Yellow -Black to Black Fig 1.4 Fig 1.5 Fig 1.11 Fig 1.10 4)IMPORTANT: Double check that no lines are crossed before launching your kite.(Fig 1.10 and 1.11) Fig 1.6 Fig 1.7 Liquid Force Tension User Guide 06...
- Page 7 7)Keep the hand pump, air valves, and the inside of the bladders clean. Avoid contact with sand, dirt, and salt water because it can cause damage to these items. Fig 1.15 Fig 1.16 Fig 1.17 Liquid Force Tension User Guide 07...
- Page 8 (Center Loop diagram shown below) (look at diagrams here) min. 100m DANGER ZONE AVOID THIS AREA FLYING ZONE ZONE BETWEEN KITE AND PILOT STAY OUT OF THIS AREA PARTNER wind WATER SIDE-SHORE WINDS LAND Liquid Force Tension User Guide 08...
- Page 9 1)The harness line must be setup as shown to avoid unnecessary strain on the control bar. 2)Harness lines placed too closely together will exert excessive pressure on the control bar and may cause it to bend or break. RIGHT WRONG Liquid Force Tension User Guide 09...
- Page 10 6)Once the bladder is completely out, the feed line fully inserted into the strut with excess line line hanging out of the tip.
- Page 11 The warranty is valid only when the warranty card is proper- ly filled out and returned to Liquid Force within seven (7) days from Warning! It is the user’s responsibility to carefully read this users guide and the date of purchase.