Advertisement
Step4: Find the edge and center of the stud and mark it.
Step5: Put the bottom magnet of the tool on the spot that you
marked in the step4, to confirm whether it is metal or wood stud. If
it is metal, please don't drill into it
Note:
1.
WireWarning detection works in all modes. The indicator flashes on
the screen when detecting a live, unshielded wire.
2.
Factors like humidity, temperature, and even the minor electric
readings from your hand, which all have an impact on the readings from
the wall.
3. If Stud Scan Mode provides irregular readings, the wood or studs
might be behind deeper than 0.5 in. (12 mm). Slide the Mode Selector
Switch to Deep Scan Mode.
Stud Scan Mode 2
Deep scan mode doubles the scanning depth of wood stud and metal stud
to 1 in. (25 mm) deep and allows for increased accuracy on deeper targets.
Step 1: Press the mode button to choose the "Deep mode"
Step 2: Put the scanner on the wall and Press the Scan Button on the
side of the tool to calibrate. After a short beep sounds, confirming
calibration is complete.
Note: Be sure not to move the scanner while calibrating.
Calibrate the tool on the wall before every scan.
Step 3: Move it flat against the wall to scan.
Note: If it finds metal or wooden stud, the screen will show as the picture
and it beeps .If it finds nothing, please repeat the above steps ( calibrate
it on a new place on the wall and move it to scan)
Step4: Find the edge and center of the stud and mark it.
Step5: Put the bottom magnet of the tool on the spot that you
marked in the step4, to confirm whether it is metal or wood stud. If
it is metal, please don't drill into it
Note:
1. WireWarning detection works in all modes. The indicator flashes on
the screen when detecting a live, unshielded wire.
2. Factors like humidity, temperature, and even the minor electric
readings from your hand, which all have an impact on the readings from
the wall.
3.If Stud Scan Mode provides irregular readings, the wood or studs
might be behind deeper than 1 in. (25 mm). Slide the Mode Selector
Switch to Deep Scan Mode.
Stud Scan Mode 3
Use this stud scan mode to find the center and edges of wood or metal
1
1
⁄2
studs up to
in. (38 mm) deep. For best results, always start in this
mode when looking for studs.
Step 1: Press the mode button to choose the "stud mode"
Step 2 ： Put the scanner on the wall and Press the Scan Button on the
side of the tool to calibrate. After a short beep sounds, confirming
calibration is complete.
Note: Be sure not to move the scanner while calibrating.
Calibrate the tool on the wall before every scan.
Step3: Move it flat against the wall to scan.
Note: If it finds metal or wooden stud, the screen will show as the picture
and it beeps.
If it finds nothing, please repeat the above steps ( calibrate it and move it
to scan)
Advertisement
