Subscribe to Our Youtube Channel
Related Manuals for anko TR-1801
Summary of Contents for anko TR-1801
- Page 1 Humidifier User Manual Read and Save These Instructions Note: The specifications and/or components of this appliance are subject to change without prior notice Model No.: TR-1801 Rev 4...
- Page 2 Page 2 of 16...
-
Page 3: Table Of Contents
Safety Instructions ................5 Components ..................8 Preparation ..................8 Filling the Water Tank ............... 9 Power supply .................. 10 Operation ..................11 Modes ..................11 Mist Direction ................11 Indicator Lights ................ 12 After Use ..................12 Care and Cleaning ................12 Ultrasonic Transducer .............. - Page 4 Page 4 of 16...
-
Page 5: Safety Instructions
1 Safety Instructions When using electrical appliances, basic safety precautions should always be followed, including the following: Carefully read this instruction manual before using the appliance. • Keep the appliance out of reach of young children and pets. • • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible... - Page 6 • Do Not allow the mist outlet to directly face the wall as the moisture could cause damage, particularly to wallpaper, plaster walls, etc. NEVER tilt, move, or attempt to empty the unit while it is operating. Switch off and unplug •...
- Page 7 Additional Safety Instructions If using an extension cord: The technical specifications of the extension cord must match or exceed the technical specifications of the Power Supply. Do not allow the cord to hang over the edge of the work surface or to come into contact with stoves or other hot surfaces.
-
Page 8: Components
2 Components Directional Mist Vent Night Light Water Level Sensor Power Adaptor - XH2400-0500wA On / Off / Mode Button with Ultrasonic Transducer Disc Indicator Light Ultrasonic Disc Cleaning Water Tank Brush 3 Preparation Always operate the Humidifier on a flat, waterproof, level and stable surface. Important: Ensure you read the Safety Instructions before use as there are important notes you need to know about to prevent injury and damage. -
Page 9: Filling The Water Tank
4 Filling the Water Tank Note: The water tank can hold 2 litres of water. Remove the water tank from the base unit by grasping the tank and • lifting it straight up then turn the water tank upside down. Unscrew the Filler Cap and remove. -
Page 10: Power Supply
Carefully place the water tank back onto the base stand and make sure • it is placed in the correct seated position. 5 Power supply IMPORTANT: The Humidifier must only be supplied at Safety Extra Low Voltage “SELV”. Only use with Power Supply Model: XH2400-0500wA Ensuring the power supply cord is fully unwound, insert the small plug •... -
Page 11: Operation
6 Operation Modes There are 4 modes being: 1. Low Mist Rate plus Night Light On 2. Low Mist Rate plus Night Light Off 3. High Mist Rate plus Night Light On 4. High Mist Rate plus Night Light Off To access these modes from when first plugged in and turned on at the power point, follow the instruction below. -
Page 12: Indicator Lights
Indicator Lights When first plugged in and switched on, the On/Off button will illuminate • Red indicating power is supplied. With the Water Tank filled and fitted to the base, and after selecting your • desired mode, the On / Off button will illuminate Blue indicating all is working properly. -
Page 13: Base And Water Tank
To clean the Ultrasonic Transducer, follow these steps: With the unit turned off and unplugged, remove the water tank. • Using the small cleaning brush and clean water only (no detergents, • household cleaners or scouring pads etc.), brush any residue off the transducer. -
Page 14: Troubleshooting
10 Troubleshooting Common problems Cause Remedy Plug in the power supply and switch it On at the power point. If still no power, check if the power point power Power Not Switched On. supplied checking with No Power to the unit (On / Off another appliance such as a button not lighting up Steady table lamp. -
Page 15: Warranty Against Defect
11 Warranty Against Defect 12 Month Warranty Thank you for your purchase from Kmart. Kmart Australia Ltd warrants your new product to be free from defects in materials and workmanship for the period stated above, from the date of purchase, provided that the product is used in accordance with accompanying recommendations or instructions where provided. - Page 16 Page 16 of 16...
Need help?
Do you have a question about the TR-1801 and is the answer not in the manual?
Questions and answers