Page 1
It's that simple! For CD Players ONLY! Installation 1- Turn the phone upside down and connect the short modular cable from the CK-1A2 box to the AT&T E2562 telephone jack that is labeled “LINE 1/ L1+L2”. (See Fig. 1). Fig. 1 Fig.
Page 2
To Music On Hold Audi o Sour ce To Telephone Lines 4- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 Line on CK-1A2], as shown in Fig. #3. 5- Locate the CK-1A2 “SENSOR BOARD", peel off the protector paper from the...
Page 3
Make sure that the SENSOR BOARD is aligned properly. Lights on CK-1 Box. When you place a line on HOLD, the corresponding LED on the rear of the CK-1A2 box lights up to confirm the music on hold condition.
Page 4
EXCEPT AS SPECIFICALLY PROVIDED IN THIS AGREEMENT, THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OR MERCHANTABILITIES OR FITNESS FOR A PARTICULAR PURPOSE AND IN NO EVENT SHALL SKUTCH ELECTRONICS BE LIABLE FOR LOSS OF PROFITS OR BENEFITS, INDIRECT, SPECIAL, CONSEQUENTIAL OR OTHER SIMILAR DAMAGES ARISING OUT OF ANY BREACH OF THIS WARRANTY OR OTHERWISE.
Need help?
Do you have a question about the CK-1A2 and is the answer not in the manual?
Questions and answers