Advertisement
air bed, such as aerosol tire repair products, as it may ignite or
explode.
•
WARNING: RISK OF SUFFOCATION. Infants
have suffocated on inflatable air beds. Never place
an infant 15 months or younger to sleep on this
inflatable air bed. Infants can suffocate on an
under-inflated or deflated air bed, on bedding, by
co-sleeping with another person, and by entrapment between
the air bed and a vertical surface. Children can be entrapped
between the inflatable air bed and an adjacent vertical surface.
Provide at least a shoulder width space between the inflatable
air bed and the adjacent vertical surfaces such as walls,
dressers, or other objects. Always keep the inflatable air bed
fully inflated when in use.
• Do not attempt to repair or adjust any electrical or mechanical
elements in the appliance. Doing so may be unsafe and will void
your warranty.
• Use the air bed only as a mattress. Do not walk, stand, jump or
use the air bed as a trampoline.
• Avoid sleeping on the edge of the air bed. Edges produce less
support than the middle of the air bed.
• This air bed is not a buoyancy aid, lifebuoy or life saving device.
Do not use it on or near water.
• Do not set up the air bed near stairs, doors, sharp edges or
breakable objects. Provide adequate space between the air bed
and objects to avoid entrapment. Make sure the area is flat,
smooth, even and free of sharp objects that could puncture the
air bed.
• Keep pets away from the air bed. Pets may puncture the
surface of the air bed.
• Ensure the air pump suction and exhaust openings remain free
of dust and debris.
6 | English
SPECIFICATIONS
Dimensions AB-K2: 203.2 x 152.4 x 55.88cm | AB-S2: 190.5 x 99.06 x 53.34cm
Weight AB-K2: 10.5kg | AB-S2: 6.8kg
Power: 150W
Voltage: AC 220-240V
Frequency: 50Hz
OPERATING INSTRUCTIONS
Parts
1. Control dial
2. Manual valve
3. Power cord
compartment cover
4. Air Bed
Inflation
1. Choose a flat, indoor surface large enough
to accommodate the inflated air bed.
2. Remove any sharp or pointy objects on or
near the surface.
3. Lay the air bed out with the bottom surface
touching the floor.
4. Open the cover at the side of the air bed
where the power cord is stored.
5. Make sure the manual inflation valve is
closed.
6. Plug the power cord into an electrical
outlet.
7. Turn the control dial clockwise until the
arrow points to INFLATE (Image 1).
8. The single and twin air bed will take up to 2
minutes to inflate. The queen and king size
air bed will take up to 3 minutes to inflate.
9. When the airbed is fully inflated, turn the
control dial one click anti-clockwise until
the arrow points to OFF (Image 2).
10. Lie down on the air bed to test the
firmness. If too soft, repeat steps 7 – 9 as
necessary.
English | 7
Advertisement
